When trying to tune a gimbal Id like to be able to quantify the difference between one set of parameters and another instead of just watching the video and subjectively choosing which is better. Considering that most video editing software can remove
Read more…I see on the Pixhawk product page it says it only work up to 8 channels on Spektrum satellite recievers. Does this mean that a satellite that has been bound to a 9 channel RX wnt work at all or that you will only get 8 channels? I have a 9 channel sa
Read more…Ive been using a set of V1 3DR radios for a while but recently my air module seems to have died. I unplugged the jumper that was powering it and since then it wont power on at all. I need a new air module and since theres no way to buy just the one r
Read more…Has anyone used an onboard wifi network to transmit data to your ground station?
Read more…I posted this in the ArduPlane section and the users group and got no response so I figure Ill try here:
I installed a Hitec Optima 7 Rx into my plane and reprogrammed the FS settings. I want the failsafe to kick in in the manual modes but not in Aut
Read more…I installed a Hitec Optima 7 Rx into my plane and reprogrammed the FS settings. I want the failsafe to kick in in the manual modes but not in Auto mode. Using the 2.4 firmware, I have GCS, short failsafe, and long failsafe set to 0. I have THR_FAILSA
I installed a Hitec Optima 7 Rx into my plane and reprogrammed the FS settings. I want the failsafe to kick in in the manual modes but not in Auto mode. Using the 2.4 firmware, I have GCS, short failsafe, and long failsafe set to 0. I have THR_FAILSA
Read more…ive been flying with my APM 1 for several months, I had my PIDs dialed in fairly well so I havent needed to update the parameters. I loaded the latest arduplane firmware a couple of days ago and also installed a new RC reciever so I had to load the p
Read more…Could somone give me some tips on how to extract radio data from the TLOG files for use outside of APM (i.e. Excel or MATLAB)?
Read more…Im running an APM 1.4 board and it was working fine up until a crash this afternoon. Thew board looks like is in good shape, I cant see any damage and when I plug in USB both boards power up and the computer recognizes it. However, I cant connect in
Read more…I just got the electronics chassis from DIYDrones and put it all together and Im wondering how to attach it to the plane. Are the magnets in the kit really enough to hold it on? How many did others use? Theres not a lot of surface area on the magnets
Read more…Im flying a HK Bixler with the APM 1.4 board and everything seems to be working properly but "Auto" mode. FBW_A seems to work very well and RTL bring the plane back to the launch location as expected. However, when I activate Auto mode 4 out of 5 tim
Read more…