Guys,I seem to have an issue with my APM 2.6 board. It seems I can no longer successfully write parameters from MP. I've tried multiple files without success, normally it gets to parameter 15 ish and then just stops.... Any ideas?I'm not sure if it…
A couple of us are experiencing issues getting voltage / current data to update (except once during arm and disarm), it's discussed on the Wiki here, any ideas?
"Argh, so yours was not wired up correctly? I've just checked mine and the OSD rx pin is connected to the APM tx port (Both rx and tx go to my 3DR radio), so I presume mine is right...
I get the OSD, but some of the numbers only update on arm…"
"Attached is a diagram showing my current system layout....
I realise there is a ground loop, but am not sure where best to remove it? I also presume that the loop is not related to the OSD brown out as I did test it with the APM -> OSD ground…"
Hi Guys,So I finally figured out why I was losing the overlay on my MinimOSD - It was browning out under load due to voltage fluctuations (See attached graph of the APM VCC graph). The rest of the components seem to be able to cope with the…
"Further info, when trying to set SR0 I see that some of my settings are being changed after a refresh. I write the new params as per the MinimOSD Extra wiki but upon refresh they are changed.
It seems I'll never get my MinimOSD working :-(I was out testing today and realised that I'm losing the overlay. I've turned off all switching in the CT tool so it's not that. I simply lose the overlay but the video remains on screen. It seems it's…
I seem to be having some issues getting this to work correctly for me.
The issues is that if I don't establish a telemetry link I get no Voltage / AMP data, the rest seems to work, i.e. heading, mode, position, it's just the Voltage /…"
Hello all,I have bridged my MinimOSD to provide 5v to both sides of the board, with this in mind do you think it's possible to power the FPV TX (Requires (6.5-15v but I'm informed it steps that down to 5v so should work off a 5v direct supply)…