Hello everyone!I'm trying to connect a gripper to my IRIS+ using Pixhawk output 2. I know that I can use RC10_FUNCTION command on my auto missions in order to turn on gripper signal but I would like to use it manually sending the signal directly…
Hello everybody! What do you think about this mission? Its about to fly in a circle with a ROI in the center of it.The "risky" part on this is flying above sea and mountains as you might see on the aereal map and the photos. Location is San Carlos,…
"Thank you for your video. This is pretty close to what I'm planning to do.
The main differente is that my inspection would be done with a pilot on the motion train, not out.
So the challenge is to take off the IRIS+ to inspect the car trains at a…"
Dear fellows: I was talking with a friend of mine this weekend about an interesting application using IRIS+ (or a similar device) in order to inspect trains.We are in Mexico and here trains are commonly used to transport raw materials like steel and…
"Just to let you know that I've got an answer from 3DR Support. They said, as many here, that I tried to took off on a non-flat surface which I did. Logs registers a big difference between the EKF1 Yaw and the actual IRIS+ Yaw, so that procuded the…"
"Thank everyone for your interesting opinions and diagnosis.
Just to let you know that I've got an answer from 3DR Support. They said, as many here, that I tried to took off on a non-flat surface which I did. Logs registers a big difference between…"