sorry for the late reply , yes the taranis has a tele port but we first have to use a teensy board to convert the mavlink messages to the FRsky protocol It is also possible to connect a blue-tooth module to the RFD900 mavlink data port and…"
"Hi I see its possible to use the radios as TX and RX for control ..so we don't have to use std rc receivers .. The question is, can it possible to get the mavlink data onto the Taranis Radio screen? Normally we would use a converter connected to the…"
"No don't think they can be configured for reverse during flight ... But you could add a crossover switch to two of the output wires from the esc to the motor then program to a switch on your transmitter, which you then flip on and off to reverse the…"
"Hi Jed ... I did not get a notification of your reply .. so i have only just seen it now .. perhaps if you respond to my friend request i can send you some info also need your email address .. I dont want to post info on here ..cheers R"
Did you buy an Altus ? I ask, as we are a local Tauranga Company and we produce a neat unit, Y6 Ti series, titanium folding arms and flight time of between 20 - 30mins min .. depending on load .. it also comes with bayonet cam lock quick…"
"Hi Ya . yes i think your are right i should try 3.3.2.on that machine, as you say it should start to slow sooner before 10m .. this is the issue, it races to 10m then tries to slow by that time its nearly touching the ground ... instead of racing…"
"Hi Randy .. I dont think posting a log would help, as I am sure its just descending too fast, to slow before Land kicks in .. It has been flying great for over a year now :o)
On a sad note a new Giant quad build 1200mm with 135kv motors and 26…"
"Yes Randy pre 3.3.2 on this machine we are still running the old version..I think it still on 3.2.1 :) It was landing fine..infact we have done so many missions with this unit with no issue .. but it is a bit heavier now and i did increase the WP…"
Well, I would like to increase the transition zone to say 14m as its a very heavy large copter and when it descends its struggles to slow enough at the land zone height and we have one hard landing already .. I know I can set the WP…"
Is it possible to change the height at which copter transitions from RTL to land .. I know you can set the land height to 0 for Land and RTL to a height to return at, but it is the section where it pauses to enter landing…"
"Hi Randy ...just to say thanks for your reply .. I have fitted a faster card i will see how that goes .. .. I have a concern with compass bar going into the red when the copter turns in Auto mode .. I have tried this with just a bare spare pixhawk…"
"Hi Thorsten, I have not had an opportunity yet to see if the class 10 card I fitted has fixed the issue.. I will find out though one way or the other ..I am not sure I like the "None Small Medium and Detailed" logging options, I prefer to select…"