Gender
Male
About
Location
Boulder Creek, CA
About Me:
Millwright by trade
Please tell us a bit about your UAV interest
My first build and just ordered Ardupilot 2.5
Hometown:
Boulder Creek
Activity Feed
"I have learned a lot over the years from reading your post. Thanks to the great insights you have given to the community. Best of luck"
"I have a newer and an older Pixhawk. The older board did not have a problem with 3.2.1. The newer board is not flyable with the new version 3.2.1 What I had to do is reload ver. 3.1.5. Are you getting "PreARm: Compasses inconsistent" on your HUD? I…"
Pixhawk 3DRCompasss/GPS 3DRTBS frame740Kv motorsPower module 3DRI can calibrate the compass/GPS module and fly with no problem but when I reboot the next day I always get this error. I am using MP 1.3.17, firmware 3.2.1. I received this Pixhawk…
"Build no. 5
Frame: TBS
Motors: RCMC 3407 750KV
Esc: RCMC 30HV SimonK ESC
Arms: 4x Multicopterbuilders Arm extensions
Rx/Tx: DragonLink V2- HiTec Aurora 9
Fc: 3DR PixHawk
GPS: 3DR
Props: HQ 11X4.5
Bat. : Turnigy 5000 Mah hard…"
Frame: TBS
Motors: RCMC 3407 750KV
Esc: RCMC 30HV SimonK ESC
Arms: 4x Multicopterbuilders Arm extensions
Rx/Tx: DragonLink V2- HiTec Aurora 9
Fc: 3DR PixHawk
GPS: 3DR
Props: HQ 11X4.5
Bat. : Turnigy 5000 Mah hard…"
"I smoked my 2.5 last year and also the GPS. Could you fix them both for $40? "
"A powered USB hub might solve your connection issues"
"Hopefully the grass is cut, don't want to spend another hour looking for my rig, but it's a hell of a place to fly. I'll be there"
I am using an APM 2.5 with a 3DR power module. I want to add in a Pololu switch.I would prefer to tie in through the power point. I thought I had the right 5VDC pin but it powers up regardless of the switch. I assumed it would be the red wired. Then…
