"I'm getting the EKF errors as well

Other than the bad gyro health it appears to running ok.

I did have some weird behavior like one of the motors not running at all on my hex and the pitch channel getting reversed that was cured by reverting to…"

"Got it to work using 3.3 RC3 and RC4. You have to update to the latest build of mission planner and set the serial port to "3" for the FrSky"

"Thanks for the all the work with the updates.
I just loaded RC4 and now getting a Bad Gyro Health warning on mission planner. RC3 worked fine.

Any suggestions?"

"Thanks for the tip!

Found the post on page 29 and got it to work. Required a reboot but working fine just like before.

robin"

"I'm trying to configure 3.3-rc1 to take advantage of the new gimbal control features with my alexmos 8bit board running 2.3 on a DYS gimbal. Excited about trying out the do-mount commands.
After hours of fiddling I can't get the gimbal tilt control…"

"got it to work.

for the RC output you need to select 29 as the option. Was not listed in the options in the latest update of mission planner so I guessed since 29 was listed for the CH option.

I'm using CH 8 as my gear switch and aux1 as my servo…"

"Trying to take advantage of the new retractable landing gear features. Running a Chinese retract set on a 600 hex on a camera rig.

Any tips/suggestions on how to configure the wiring and parameters? In lieu of the gear mode is there a simple pass…"

"I'm having the same trouble. Connected it just like you and using the latest 3.3 rc1.

Tried changing the baud settings for serial port #2 with no luck.

Any luck getting it to work?

robin"