Gender
Male
About
Please tell us a bit about your UAV interest
Auto flying
Hometown:
Korea
Activity Feed
"Hi Sander,
What's your plan to provide modules on market?"
What's your plan to provide modules on market?"
"@Randy,
I've air tested with one fixed wing and Quad.
Quad : Connected with GCS
Fixed Wing : Daisy chained with Quad
Fixed wing flew by 3km away from home in Guided mode and I clicked button RTL in MP several times but it didn't work.
So I landed…"
I've air tested with one fixed wing and Quad.
Quad : Connected with GCS
Fixed Wing : Daisy chained with Quad
Fixed wing flew by 3km away from home in Guided mode and I clicked button RTL in MP several times but it didn't work.
So I landed…"
"I think this is not a i2c splitter issue itself but i2c inteferance. There was a same article on it. http://diydrones.com/forum/topics/i2c-splitter-problem?page=1&c..."
"I have exact same issue too.
Stijn, did you find to solove this?"
Stijn, did you find to solove this?"
"Thanks to Goro, Pual, Randy.
I got Optical Flow works well. Here is the video clip fling with OF
P.S : The GPS is for only mag sensor not GPS"
I got Optical Flow works well. Here is the video clip fling with OF
P.S : The GPS is for only mag sensor not GPS"
"I've set multi-vehicle for ground test as below
But I found issue on traffic - data rate.
The wiki says in order to reduce data rate, to do like below image
But I experienced bigger latency of artificial horizon refresh than I expected.
It's…"
But I found issue on traffic - data rate.
The wiki says in order to reduce data rate, to do like below image
But I experienced bigger latency of artificial horizon refresh than I expected.
It's…"
"Yeh, just downloaded via MP"
"Yes, what I did
GPS=disconnected
GPS.Mag=connected
FlightMode=Loiter
and it was perfectly armed."
GPS=disconnected
GPS.Mag=connected
FlightMode=Loiter
and it was perfectly armed."
"Thanks Goro,
I found it had not only one problem ^^;
1st, I've set parameters to what you mentioned but still not armed.
2nd, my OF has power issue so I had to power it up via USB first.
( I have two OF but both have same issue -.- )
3rd, the worst…"
I found it had not only one problem ^^;
1st, I've set parameters to what you mentioned but still not armed.
2nd, my OF has power issue so I had to power it up via USB first.
( I have two OF but both have same issue -.- )
3rd, the worst…"
"Hi Paul,
FW : AC3.3.3 RC2
Pixhawk
I'm still struggling with OF.
I found that Lidar is indicating correct alt and OF log is shown in MP's log analyzer ( but not match each other OF.flow, OF.body IMU.Gyro like wiki )
Even with AC3.3.3 RC2 +…"
FW : AC3.3.3 RC2
Pixhawk
I'm still struggling with OF.
I found that Lidar is indicating correct alt and OF log is shown in MP's log analyzer ( but not match each other OF.flow, OF.body IMU.Gyro like wiki )
Even with AC3.3.3 RC2 +…"
"Hi Warren, for air rover side, 3dr radio v2 can be used?"
Hi,I've experienced FailSafe of "No GCS heartbeatmany" times but what I don't understand is that Hud is still saying 93% RSSI(?) at the FS moment.It'll be very appreciated if someone would tell me why the FS occured even with 93% RSSI?Fyi, my plane…
"Hi Paul,
I'm not clear with wiki on how to calibrate OF. It just says "calibrate" but not more explanation. Could you help me to get further information on calibration?"
I'm not clear with wiki on how to calibrate OF. It just says "calibrate" but not more explanation. Could you help me to get further information on calibration?"
"Hi Paul, I'm not sure why log shows like that and I've tested it indoor like space under big bridge which protected GPS signal perfectly. I'll do test it again. Thanks for your comment ^^"
"Thanks Goro, I'll try again and let you shared on the result ^^;"
