About

Gender

Male


Location

São Paulo


Please tell us a bit about your UAV interest

Aerial Mapping


Hometown:

São Paulo


Activity Feed

Sergio Couto replied to Sergio Couto's discussion Voltage Monitor calibration with 6S lipo in PIXHAWK
"Sorry. Yes. Everytime i enter in the voltage monitor screen the type is set to OTHER."
Dec 6, 2015
Sergio Couto replied to Sergio Couto's discussion Voltage Monitor calibration with 6S lipo in PIXHAWK
"PM?"
Nov 23, 2015
Sergio Couto replied to Sergio Couto's discussion Voltage Monitor calibration with 6S lipo in PIXHAWK
"Measured Battery Voltage... The first field in the Battery Monitor screen.

Isn't it?"
Nov 23, 2015
Sergio Couto posted a discussion in PIXHAWK
Hello. I'm using a pdb that accept 6S and gives voltage to Pixhawk, current/voltage sensor, 5V and 12V too.But unfortunately i can't calibrate the voltage readings in mission planner. When i change the voltage appear an invalid number message.Do you…
Nov 16, 2015
Sergio Couto replied to Marek's discussion Simple printed Samsung NX1000 2-axis gimbal for otophoto
"Hello Marek. Very nice and usefull.
Is it working well? Any update to this gimbal? Thank you."
Sep 22, 2015
Sergio Couto replied to Ben Garcia's discussion Samsung NX Mini
"Hello Raul.

How is the NX1000 is about jello/vibratons?

Thank you."
Sep 14, 2015
Sergio Couto replied to Steve Cain's discussion Pixhawk PWM input for RSSI (EZUHF)
"Hello,

I'm trying to only show the rxRSSI information (from the ezUHF) on the Mission Planner HUD.

No OSD.

Do you have an idea why i can't see it? the info is in the PPM stream at ch8 as usual.

Thank you
CreativeBR"
Aug 29, 2015
Sergio Couto replied to abhra ghosh's discussion PIXHAWK with EMAX BLHELI ESC NOT WORKING
"I'm thinking in flash SimonK to them..."
Aug 27, 2015
Sergio Couto replied to abhra ghosh's discussion PIXHAWK with EMAX BLHELI ESC NOT WORKING
"I'm having this "no spin after armed" behavior with 30A Rotorgeeks BLHELI 13.2.

Sometimes after several boot tries the ESC beeps after i press the safety switch and the motors spin.

I guess this resistor mod will not work with the rotorgeeks. Is…"
Aug 27, 2015
Sergio Couto replied to xoltri's discussion Pixhawk causing motor sync issues.
"I trying to use these RG ESCs with just the signal wire (one of them has the ground and it is connected) and i cant complete the ESC calibration and the PixHawk aways ARM but sometimes de motors spin sometimes not.

I'm not sure what is the problem.…"
Aug 27, 2015
Sergio Couto replied to Chris's discussion Pixhawk setup problems - can't throttle up ESCs
"I have a similar problem...not sure.

Everything works to me but the ESC calibration.

The Pixhawk goes in calibration mode.
Then it makes that long noise from the upper throttle recognized.
I press the button but when i lower the throttle stick…"
Aug 26, 2015