"James, I was wondering what you are doing wrt image processing. I have been toying with the idea of modifying a handwriting recognition algorithm to see if it will do the job for shark recognition. Any thoughts or experience in this regard?"
I just did a quick check on helium prices and it isn't cheap ($135 / 1,150 liter tank retail hire) - with some saying the price is going to increase quickly. However, it still beats the pants off a $4000/hr…"
Youtube linkJames Masterton has been experimenting with UAVs (unmanned aerial vehicles) off the Perth coastline to see if they might help spot sharks. Here he shares his experiences and provides some clues as to what now needs to be done if UAVs…
After some faffing about I believe I have nailed the problem. It appears that proximity to the 3DR radio transmitter was interfering with the satellite antenna.
Problem now solved and satellite reception is back on line.…"
Hi. I have had the Ublox + APM 2.5 combo for a little while - and has been working great...until now. I haven't used the machine for a few months (winter) and have just taken it out of the storage box. However, all I am getting is the solid red led…
Can not get my artificial horizon to level in the Mission Planner anymore.I have carried out the "Accelerometer Calibration" in the "Configuration>ArduCopter Level" section of Mission Planner and no joy.Then I did the in-flight trim as per…
"Interesting to hear about your experience. I have a QAV500 as well. It has been okay so far except that it does not respond terribly quickly when increasing throttle to slow a descent. Very difficult to slow down in a descent. I was…"
""Any chance of a pic of how the new 3DR Radio connectors should be configured? There seems to be an extra wire on the adapter that was shipped with the APM2.5 v the APM2.0"
OK - found the answer…"
"Any chance of a pic of how the new 3DR Radio connectors should be configured? There seems to be an extra wire on the adapter that was shipped with the APM2.5 v the APM2.0
"Parameter: THR_RATE_D is 0.02 by default, but the noise of the Baro sensor can cause issues. If the value is too high you will see bad oscillations or pulsing of the motors. Once the THR_RATE_P value is dialed in,…"
Hello. I was wondering if anyone may have some suggestions for tuning this machine. I have attached a video in which you can hear how the motors are behaving. Once I switch modes from stabilise to RTL, you can hear the motors pulse as the quad…