I am trying to figure out what are the internals of the LaserWorks (Boblov) LE-032 700M Laser Range Finder as far as laser-module used. Also, how does it compare with the LightWare SF11/C (120 meter) module?
I may have missed previous posts, but could not find a definite answer concerning Quadcopter frame design: are square or tube type arms and/or frame better to reduce vibration? Which is better when it comes to vibration: aluminum or carbon fiber?
Anyone found a good solution for mounting a camera on an airplane that has a propeller on front? I was concerned about the propeller rotation interferrign with the view. Would mounting on the wing make the plane fly unbalanced as far as airflow?
I am wondering if anyone came up with a custom solution or has some tips to avoid the spaghetti wires for APM2 or any other circuit boards? I was thinking about a ribbon cable and headers, but using that the entire system would need to be customize
Is there a way to load ArduPlane on APM2 with Ardunio environment using the old ISP cable? Or any other way to load it? I cannot get it to load via the USB cable. It works with Mission Planner using the automatic firmware and USB cable and the 2560
Turnigy 9X elevator potentiometer does not work correctly in one direction. It drops to zero Ohms after about 3.8 KOhms instead of moving all the way to around 5 KOhms. Did anyone repair or replace it before? I saw a post that used conductive paint.
Haven't used Arduino to compile any code for a long time, but had no issues in the past.
First problem: need help with ArduPlane 2.2.8, it won't compile in (the latest) Arduino environment, even if I did not touch the APM2 code at all. It has about a
Would like to ask for assistance with a 0-25mV pressure sensor that is made of a piezo bridge. The excitation voltage is 10V. How could I increase the 0-25mV to 0-5V or 0-10V without introducing a lot of error when the inherent accuracy is+/- 2%?
I am planning to add flaps to the plane and wondering if I should just add it as an extra channel on the transmitter or should I incorporate it into the APM 2.1 code.
Would it effect the "stabilized", "fly by wire" etc mode flying, or APM would comp