About

Gender

Male


Location

Ontario


Please tell us a bit about your UAV interest

It is my hobby


Hometown:

Toronto


Activity Feed

Vlad M. replied to Randy's discussion PixRacer with Ardupilot
"Hi Andrew. 
There is no difference in other RC calibration values between PX4 and APM versions. here is the channel 2. 

RC2_DZ,30RC2_MAX,1964RC2_MIN,1054RC2_REV,1RC2_TRIM,1054

1 1 RC2_DZ 10.000000000000000000 91 1 RC2_MAX 1964.000000000000000000…"
May 15, 2016
Vlad M. replied to Randy's discussion PixRacer with Ardupilot
"Thank you Andrew. I did a couple of quick tests to make sure RC_PWM values are correct. Here are my PX4 values
1 1 RC3_MAX 1962.000000000000000000 91 1 RC3_MIN 1055.000000000000000000 91 1 RC3_REV 1.000000000000000000 91 1 RC3_TRIM…"
May 14, 2016
Vlad M. replied to Randy's discussion PixRacer with Ardupilot
"Today I tried APM:Copter V3.4-dev (388a6683) and my ESCs are still not starting after the boot. With PX4 I am getting 5 long beeps during the boot (I am running on 5s). With APM two long beeps and then continues short beeps. I believe it is…"
May 13, 2016
Vlad M. replied to Randy's discussion PixRacer with Ardupilot
"Hi Andrew, Could you please notify here when the issues will be fixed. I have the same problems with ESC not starting and no COM link after few seconds.
I will be more than happy to test it on the bench. I am not confident flying my drone with this…"
May 11, 2016
Vlad M. replied to Randy's discussion PixRacer with Ardupilot
"Today I loaded px4 stack and tried to calibrate everything and ESC calibration worked. I can arm and start motors. Is something with APM stack, not the hardware."
May 10, 2016
Vlad M. replied to Randy's discussion PixRacer with Ardupilot
"Hi,

I am trying to troubleshoot issues with my ESC and PixRacer. Yesterday I solderd all the connections  to my Splash Drone. I believe it is XWing 40A ESCs.
And as soon as I connect power it beeps constantly every second. It is doing the same if I…"
May 9, 2016
Vlad M. replied to Randy's discussion PixRacer with Ardupilot
"Thank. I will try to test it with the latest build. With my 3DR PixHawk I am able to measure voltage without even arming the motors, it may not be very accurate, but close. With PixRacer I was getting way low values and it triggers falisafe, so I…"
Apr 15, 2016
Vlad M. replied to Randy's discussion PixRacer with Ardupilot
"Is the voltage/current sensor working on PixRacer? I have ACSP4 and cannot make it to show any reasonable values."
Apr 15, 2016
Vlad M. replied to Randy's discussion PixRacer with Ardupilot
"I have the same problem with my PixRacer. So far used QGroundControl to flash APM. There is a special option for that. Still playing with everything on the bench. Have GPS/radio working, but cannot make APM to read correct voltage/current from  ACP4."
Mar 30, 2016