Gender
Male
About
Location
Bsas campana
About Me:
Like the electronics , the challenge to build multi myself, and learn in the process, spend lot of time on the bench, not very good flying yet..
Please tell us a bit about your UAV interest
Arducopter quad, hexacopter arducam minim osd, FPV, Y6. Programming Leds. Systems , mavlink
Hometown:
aRgentina
Activity Feed
"very clear thanks"
"could you please tell me if this phone would be ok?
http://www.ebay.com/itm/Unlocked-Nokia-Lumia-521-GSM-Windows-Phone-..."
http://www.ebay.com/itm/Unlocked-Nokia-Lumia-521-GSM-Windows-Phone-..."
"thank you Martin, i would have to find a pair of W8 phones first , will make contact as soon as have it covered ,."
"your development is fantastic ! , congratulations and my respect to your skills .
i would definitely try the system on my Pixhawk drone ,
i would need to buy a phone, is any Window phone that would recommend , does it has to be windows mobile…"
i would definitely try the system on my Pixhawk drone ,
i would need to buy a phone, is any Window phone that would recommend , does it has to be windows mobile…"
"did anybody found a successful way to link telemetry over wifi, using the esp8266 with a pixhawk , most like the development for pixracer , ??"
"I don't see it been practicall , no way soon if always the way is advertised on the title , it is just the old and known wireless charging station , ( high freq "transformer " , that could be valid to any , electrically powered device )
unless…"
unless…"
"Thanks DG, after playing a lot of different combinations on ecalc, I have reached to the conclusion that the copter is underpowered and that my first move ( higher impact lower cost) must be to change battery from 4s to 5s,.
So have to order new…"
So have to order new…"
I have just tested my y6 in flight ,Controller pixhawkEsc afro 30aMotors multistar 4220 390Bat 4s 5000All up weight 2.9 kgProp CF 15" x 5.5I have identified a problem that is lack of final RPMs., thinking that it a maybe a tunning problem , I tryed…
"When connecting The Orange 910 receiver to RC input ,IT works , but The channel assigment is incorrect ,and The RCmap parameters are no table to correct The Mapping error,.
Then The only way to use a spektrum control with pixhawk today is buy using…"
Then The only way to use a spektrum control with pixhawk today is buy using…"
is there a way to connect the TM1000 to pixhawk ?the purpose id to have basic telemetry on the Spektrum TX screen .anybody have DSM2 or X , hardware spec to see if the Tm1000 and satellite can be daisy chained to the Pixhawk port?thanks
"that function should be very useful to use the gimbal for FPV, then "locking" the gimbal in a fixed position ( no stabilization at all), it may seam useless but it is not , you can use your camera for FPV by eliminating the stabilization effect ,…"
"Hi marcin,
Schenoni using a ground module, is it necessary to cut the wires going to the ftdi chip, or can be soldered in parallel , tx and Rx ?
Thanks"
Schenoni using a ground module, is it necessary to cut the wires going to the ftdi chip, or can be soldered in parallel , tx and Rx ?
Thanks"
"Trung, have you finally modified the 3dr ground radio, to connect tobt module?, I'm curious if it can be connect directly without cutting the board connections to the USB ic.
Thanks"
Thanks"
"Hi , do somebody have clarity on how to hook up the spekteum satellite ppm connection to APM2.5?"
