healthyfatboy's Discussions (22)

Sort by
T3

How to Get Logs from APM 2.5

Okay, I got a run in yesterday and thought it did great! There's definitely more I can do to make it better. However, to do so, I need logs and for whatever reason, I didn't get logs of any of the runs I tried last night. I'm using an APM 2.8 from RT

Read more…
T3

Compassmot issues using CLI and MP

My setup:
TBS Disco with a Pixhawk
3DR GPS/compass combo
3DR Power Module running a 4S system
V1 3DR Air telemetry module connected to Telem1
Teensy 3.1 connected to Telem2 going to FrSky X8R for telemetry to Taranis
Running DJI 920kV motors and 30A OPTO E

Read more…
T3

Tuning Questions

I posted this set of questions on the ArduPlane 2.X forum but haven't seen too much activity over here and though I would post this to the group as well. I've modified this posting a bit as I found answers to a couple of my questions in subsequent up

Read more…
T3

Board Orientation and AUTO Mode

Okay, so as I was trying to figure out what was wrong with my throttle, I swapped the radio system out to the stock Traxxas receiver. I use a 4 channel remote from a Summit and modified the thumb switch to 3 positions so I could use a ground radio to

Read more…
T3

Unexpected Throttle Behavior

I just loaded up 2.4 in my APM 2.5+ and went through the calibration process and set the throttle parameters and am experiencing unexpected behavior for the throttle. When in manual mode, steering works as expected, albeit courser resolution, but thr

Read more…
T3

900MHz 2dBi Antennas

Is there anything special about the antennas that are out of stock or can you can pick up any 900MHz RP-SMA antenna and use them with these? I'm considering ordering the parts without the antennas and just picking them up elsewhere.

On a separate note

Read more…
T3

XBee Footprint 3DR Radio TimeFrame

Is there a time frame for when you think the XBee footprint version will be out? I finally got around to ordering an APM2 and got an "Air" module of the new radio but now am wondering if I should have held off on the single radio as it will be fairly

Read more…