About

Gender

Male


About Me:

Hi there


Please tell us a bit about your UAV interest

Electronics


Activity Feed

hikkakaru commented on CrashingDutchman's blog post Hobbyking i86 and i86L (Lite Edition) Multi-Rotor Control Board
"agreed Jack,

If they are anything like every other turn pot i've ever used, just let them sit a week or two and they'll jam irreversibly, never to be turned again.

problem solved."
Jun 27, 2012
hikkakaru commented on Gisela & Joe Noci's blog post SurVoyeur, the Rugged Electric Flyer from NamPilot, Namibia
"I think what r_beflevre was referring to was why not use a upwards rear mounted motor/prop, like for example a Skysurfer or Bixler. Hand launching is okay with those types, and certainly cuts down on noise if you were to use the plane in an FPV…"
Jun 27, 2012
hikkakaru commented on Alex Muir's blog post What do you want from motion capture?
"Honestly, I think that if motion tracking is going to become a part of the hobbyist scene, I see it happening with consumer motion tracking devices like the Kinect and it's future revisions. Not accurate or fast, yet, but it's cheap and it has a ton…"
Aug 9, 2011
hikkakaru commented on Bart's blog post Copter-GCS with Mission Support and more
"@Bart, is there any reason you use a BlueSMIRF Gold, rather than a silver? Since the range is made up with the XBee conversion, why use the longer range, more expensive bluetooth antenna? Is there more to the Gold than range?
 
Also, will the dongle…"
Aug 9, 2011
hikkakaru commented on Bart's blog post Copter-GCS with Mission Support and more
"Hi there.
 
I've read that Android doesn't support serial over host-usb. What about using a bluetooth-serial adapter like the folks doing the android/multi-wii work at RC Groups are using? (…"
Aug 8, 2011
hikkakaru replied to geir's discussion simple mode forgets bearing
"Do the filter pads on the IMU have anything to do with the magnetometer data stream?"
Aug 8, 2011
hikkakaru replied to Mike O's discussion RC transmitter mixing instead of flight controller?
"rotor-platforms are very dynamic for just straight mixing. The gyros are constantly giving the control system a means of being able to tell how much input or output that motor is giving out. There are no encoders or anything of the like on the…"
Aug 8, 2011