Gender
Male
About
Location
Norge
Please tell us a bit about your UAV interest
Commercial photo, video and photometric.
Hometown:
Bodø
Activity Feed
"Im using real Pixhawk from 3DR
Can MOT_TCRV_MAXPCT be relevant??? mine is set to 93 for unknown reason. But that is outside range (20-80) according to http://copter.ardupilot.com/wiki/arducopter-parameters/#Thrust_Curv.... Anyway, the value give a…"
Can MOT_TCRV_MAXPCT be relevant??? mine is set to 93 for unknown reason. But that is outside range (20-80) according to http://copter.ardupilot.com/wiki/arducopter-parameters/#Thrust_Curv.... Anyway, the value give a…"
"I have similar problem. I cant get full trhottle out and I have calibrated ESC and checked THR_MAX to be 1000. Here is the logg stream during test.
On a previous log fra a real flight, I can see similar behavior; thr out is below thr in even during…"
On a previous log fra a real flight, I can see similar behavior; thr out is below thr in even during…"
Updates:2014-03-31 Transistor value changed to make the 5-way selector steps linear.BackgroundIm professional pilot and are drilled to allways think more stebs forward and allso to let the tecnologi help us humans from doing stupid things. We are…
"Today I expired the second time with abrupt altitude drop in ALT HLD and LOITER mode. The last situation ended in a crash toground (very lucky for me there were no damage (and I cant understand why)).
It hapand many times during my flight, small…"
It hapand many times during my flight, small…"
"(Did a new post because the later was wrong. Thank You Goncalo!)
Despite of the "Ready to FLY uBlox OK" message I did a successful calibration (level routine / Accelerometer Calibration) in MP 1.2.47. It seem to be a "visual" bug (the messages is…"
Despite of the "Ready to FLY uBlox OK" message I did a successful calibration (level routine / Accelerometer Calibration) in MP 1.2.47. It seem to be a "visual" bug (the messages is…"
"I get "happy" values way off the values in the tuning guide (and the most of you other too). I get
Rate_P = 0,3200
Rate_I = couldn't find a value here with sense. Nothing happend, but I will try outside later.
Rate_D = 0,0230
I run the 3DR Hexa B…"
Rate_P = 0,3200
Rate_I = couldn't find a value here with sense. Nothing happend, but I will try outside later.
Rate_D = 0,0230
I run the 3DR Hexa B…"
"I solved my similar problem by changing from shielded to unshielded cable between the camera and OSDMinim. I have no idea why it helps... (I would have guessed that shielded would be best; but not in my case...)"
"I solved the problem when I changed transmitter FRAMERATE from 22ms to 11ms (better described few posts above).
Is this an interesting findings in the work to try to permanently solve the problem?"
Is this an interesting findings in the work to try to permanently solve the problem?"
"Se this tread. Maybe relevant"
"I had exactly same symptoms with APM2.5 and 2.9.1. Using Spectrum DX8 and PWM. I think I have solved the problem when I went to the Transmitter SYSTEM SETUP menu and changed FRAMERATE (from 22ms) to 11 ms. Have tried a lot of times now without…"
Im new in this and wonder if the arducopter (w/6 engines) can fly with one engine failure. Maybe it will decend and make a "soft" landing, or will it go crazy and crash?
