Gender
Male
About
Please tell us a bit about your UAV interest
I love all type of UAVs
Hometown:
NY
Activity Feed
HiMy Quad flies well, I don't have a specific problem with it, does the mission properly, flies good, everything seems good. But when I watch the flight data live time in APM mission planner, I see some aggressive behaviour like it goes down and up…
"Still having same issue..."
"@Bill, Logs wasn't enabled, I was disabled it for testing and forgot to re-enable it.
@Saurabh,what's cause? what's reason for having such bad behaviour for some of us?
Any idea?"
@Saurabh,what's cause? what's reason for having such bad behaviour for some of us?
Any idea?"
HiI had an auto waypoint flight yesterday, mission was like this: Go to point A, altitude 300From A go to B, altitude 400From B go to C, altitude 400RTLLand When I switched to auto via my controller, at first quad started to do some yaws, like 3-4…
"Any DO SET SERVO experience?"
HiI'm flying using APM 2, it's a Quad copter. I've used Output pins 1-4 for quad ESCs. I have an additional servo for controlling an arm.In Mission Planner WayPoint defination, how can I tell to send a specific PWM to for example Output pins 5 or 6,…
"a) What could be reason for runaway? How to solve it? Last command in my mission was to land, it started to go higher and higher then moved further and started decreasing.
b) I can't move further, ESC is almost connected to ESC.
c) I already have…"
b) I can't move further, ESC is almost connected to ESC.
c) I already have…"
HiI have a 60amp esc and 850kv 450 watt motors. They should create so much noise.I have ESCs in about 60cm distance of APM. maybe further. Connected ESCs close to motors and motor to motor distance is 1M and my center have about 40cm height and APM…
"How did you solved your problem?"
"Assume I've found Stabilize and Rate PID settings, what should I write in Loiter Speed and Loiter PID and WP PID?
Should I also try to calibrate and do hand test for Loiter and WP part? How I can set them from PIDs I found out working well for…"
Should I also try to calibrate and do hand test for Loiter and WP part? How I can set them from PIDs I found out working well for…"
"Is it same as Stabilize PID? How to know?"
"I see a lot of people have this problem, no good solution yet?"
"Yes, frame is balanced, tested with wires. Motors and props, everything is same"
HiI've set my Quad PID setings with some tests, Roll and Pitches are mostly locked for people. But mine is different.I set PID for Roll and Pitch, my quad goes well to left and right, but when I try to move it front and back, it's really really…
