He claims the industry not have done any development the last 100 years !!
Google translation of the article here...
After reading this I think no longer time will have same priority when I'm charging my batteries.
Read more…Somewhere in mission planner maybe in Missions.
When i disconnect battery and connect via USB (a typically routine) the warning of battery (of course) speech is annoying and the the only way to stop it (as far as I know) is to go to Configuration tab
Read more…I have seen a "how to" on flashing the GPS, but can't find it when i need it.
My GPS is 3DR GPS Lea 6 v1.1 connected to APM2.5 board.
Can i do this flashing with FLIP and my board connected with USB? Or do I need a cable between GPS and USB directly?
Read more…I just bought a DJI FlameWheel F-330 basically because i want a frame which guarantee me an exact angle on each motor. This way i can eliminate an important element of failure and getting my quad out of sync.
Here is my complete configuration:
DJI Flam
I have noticed this since i started with my APM2,5 board but focused on other stuff until now.
I have my declination values correct (2,155041) and my satcount is 9.
Also my quadcopter icon in MP is a + Quad and not a x Quad as i have defined.
I enclose
Read more…When takeoff in stabilized mode every thing is going smooth. After hovering very steady for 30-40 seconds it start to right yaw about 90 degree. When i try to yaw with my stick opposite direction it have no effect at all and i have to land.
I also tri
Read more…My GPS is working fine with my APM2.5 board connected via USB.
But with power from my 2s7,4 lipo the blue led on GPS antenna board is absent and no GPS counts.
If I start with USB connection, then connect my battery and then remove the USB cable the bl
Read more…Finally i got simulating to work (only with plane).
I'm using X-plane 10 & MP 1.2.27
First off all my throttle is very low, so i have to pump up the values throttle gain in MP simulation tab. This way i have no option to slow down the throttle but at
Read more…I'm used to fly KK2.0 with low voltage alarm (buzzer). Is this possible to set up in my APM2.5?
Read more…