Gender
Male
About
Location
Spring Hill, TN
Please tell us a bit about your UAV interest
Multirotor, http://www.aplanding.com
Hometown:
Spring Hill, TN
Activity Feed
"I think if the place will take it back it's going back. If they won't take it back it's gonna get set on a post at my shooting range."
"Hell what do I need to do, sprinkle pixie dust and get it blessed by a Shaman? Shouldn't be that hard and there's not much room to move things around. I've seen APM's on a lot smaller quads than I'm running GPS and all. I pulled the red power lines…"
"Damn, what I have a bad board? That's what I get for buying one off Ebay."
"See anything better?1 12-31-1969 4-00-00 PM.bin.log1 12-31-1969 4-00-00 PM.bin"
"Maybe that's my problem. I'm not using the power module, I have the jumper on and I'm powering everything from the ESC's."
"As requested.1 12-31-1969 4-00-00 PM.bin1 12-31-1969 4-00-00 PM.bin.log"
Hoping someone can point me in the right direction… no pun intended.Done all the calibrations, have a good GPS lock, etc, etc, etc. When I go into loiter mode it wants to start to bank left and slowly fly off. Sometimes it even does weird things…
"I did, no criticism meant. I enjoyed the video. Are you saying I wasn't modern 20 years ago? :-)"
"Fun video but he didn't go back far enough. Nearly 20 years ago there was a small group of us in the US that were doing aerial photography with wireless downlinks and yes, it was still 35mm film cameras back then. I still maintain I was the first to…"
"Love my GP but they are just too damn expensive."
"I don't know what it is with quads and alike but they seem to out of the blue just fall out of the sky... and with regularity."
"I was trying to re-calibrate but it wouldn't take."
"Tried 3.2 through APM Planner 2.0 but it won't take a compass calibration now. Just continually says compass not calibrated. If I go back to the old firmware it's fine."
"Ten bucks says if he would have immediately pulled out his ID, turned off his camera, used sir a couple times, explained what he was doing and explained he didn't realize there there was an ordinance they would have let him walk with his Phantom. "
"Interesting, I just bought a 3D printer too. I need to swap back and forth my Black Pearl though."
"Here's how I did my quick disconnect for either my Nexus 7 or my Black Pearl to my Taranis radio. After rummaging through my box of GoPro mounts I found a combination that works pretty well along with the standard eBay universal carbon fiber tx…"
