Can someone point a formula or tell me how to calculate an area in km2 or ha that a UAV can cover? Lets suppose I'm using a 24mpixel camera with 6000 x 4000 resolution. Mission planner is telling me that with this camera + 18mm focal lengh and 200
Ok, I was contacted today to see if its possible to build a quadcopter that could flight for at least 10 minutes with a small camera recording a flooded tunnel (it has artificial illumination) that has 4 x 3 meter and the bottom is water.
I'm having a strange problem with my APM 2.5 on arduplane.
After arming and after a few seconds testing servos and motor (ground) both servos and motor stop working altogether and I have to turn off APM and turn it on again for it works, and then
I'm looking for someone that can make a nice composite airframe, like the penguin-B but not so complex of course. I made a 3D rendering of the Mugin and a nice composite version of this airframe would be enough for me. Its for an UAV in my country
I want to do something but don't know how, please can someone give me some ideas?
We will start building an UAV Plane next month that will carry a CX760 camera, mainly because it has a very good stabilization system even with the optical zoom at m
I have some UAV clients here that don't undestand english and I want to translate the APM "going to waypoint X", "altitude x" etc to my language. How can I do this?
Is there any software out there that can count a cattle head numbers? Like, I take a serie os pictures and put these pictures in a computer and a software counts the numbers based on image recognition? I don't need real time recognition...
I have marked my waypoints as 80 meters and some days ago it was working at the exact (79-81) altitude, but last flights I get 55-59 meters even if the waypoints are 80meters. Its a 5 waypoint mission and it doesn't climb... its not the motor, its
I´m having some noise in channel 2 (left elevon of my X8 wing) and not on channel 1, so I want to change channel 2 output to channel 6 output so I can get rid of the noise. I tried to change (in mission planner config) the RC5_function to aileron, bu
Well, I can't disarm the plane. As soon as APM finishes the calibration procedure it just ARM itself (yellow light and ARMED message at HUD) and I can't disarm it, not even with the button arm/disarm in ACTION menu. I did a reset and installed the fi
I configured a wing plane and it flighs very good with manual mode, trimmed and all. I tested stabilize in ground and everything works fine. But right now I was flying and turned STABILIZE for the first time, and it went down like a missile, I alr
My APM 2.5 starts and goes directly (after calibration) to B yellow LED ARMED and I can't disam it, my TX is calibrated and working with APM, I can connect APM via wireless telemetry, but even if I press the mission planner DISARM button nothing h
I already translated some software to Brazilian Portuguese, like NopCommerce (.NET) and some PHP Scripts. I would like to translate Mission Planner to Brazilian Portuguese since there is an growing comunity here in my country that would benefit fr
I'm trying the GRID function but couldn't find any info about the difference between the two. I tried both and can't see a difference. Can someone tell me the difference? Should I used GRID or GRID V2 for mapping?