"Hello hello.
Short question. Is there a howto connect my Hardware? I have an android phone and a 3dr transmitter for telemetie data with an USB connector. Do I just need an adapter?
Hello hello.My arducopter drives me insane. I can not get the thing to fly stable. As far as I can see now, the calibration is wrong. The frame stands on the ground and the mission planner shows me that the copter is looking down.Is the the…
Hello hello.I just tried to launch my new adrucopter. Instead of flying it tries to make a backflip! I think something is wrong with back & forth. What I have done so far:- Checked that the APM is build in correct (The arrow points to forward)-…
Hello hello.I am in process of assembling my Arducopter quad. So far so good. Also I have read the instruction on how to connect the Powerlines within the modell, I have a question when it comes to connecting the motors.In the manual is…
Hello hello.I just received my 3DR Quad and assembled it. I have a small question. How to connect the cable from the 4 ESCs to the Arduino? I ave a 4 bin connector with the 4 colored wired from the ESCs that should fit on the 3x8 connector. I would…
Hello hello.I want to ask, if somebody has experience to use an android phone attached to the drone to exchange the telemety data via Wifi with the mission planner. The setup would look something like this:Missionplanner -> TCPIP -> Wifi -> Android…
Hello DIYforum.I want to buy the ArduCopter set "3DR ArduCopter Hexa-B Frame + Motors + Full Flight Electronics Kit". Since I am new to this rc and drones business I have the following question that I could not figure out:Is it possible to fly this…