It's amazingly difficult to find information on this subject.
I'd like to control the pitch, roll, and yaw, of my gimbal (Storm32 controller), from the control outputs of a Fatshark Trinity headtracker (mounted in Dominator V3's), using a Pixhawk, Tar
I balanced my props and did the HDMI cable mode...and I still have micro jitters. So I tried Prodad's Prodrenalin V2, which is supposed to address micro jitters and such...(version 1 did NOT address those
I'd like to control the Solo via 3DR telemetry radios (perhaps for greater control range vs wifi). Is there a way to connect a telemetry radio to the Solo? Thanks...
Kinda of a silly thought, but since I own a Phantom 3, and a Pixhawk-based hexacopter (that normally uses 3S batteries), I was thinking it would be nice to consolidate my battery purchases.
Of course the P3 battery is about $140, and I can buy equival
I'd like to ensure that my F550 reaches a waypoint altitude before moving on to the next waypoint (more important of course flying UP along rising terrain than the other way around).
I created a flight plan in Mission Planner flying up along rising terrain...out and back down...using altitudes where I would clear the terrain by 350 feet.
After I upload the flightplan to the Pixhawk, and the
When planning a mission and setting the speed between waypoints, I'd like enable the Pixhawk to automatically set max speed so as to maintain altitude. (Well heck, also when I am NOT flying a mission.)
I have a Pixhawk connected to a 3DR telemetry radio and a Minum OSD, using the Telem 1 and 2 ports, and I now want to hook up the FrSky/Taranis telem adapter board.
I am having a few serious issues, and this is one of them.
Flying along...all is well (stabilize mode), plenty of battery power, and the hex went to IDLE...tumbling down out of the sly, then all on it's own, power comes back on
I had a crash a couple weeks ago ("moderate" impact?...APM case intact), and am wondering about the integrity of my APM 2.5+ and it's accelerometers and other sensors.
When I connect to Mission Planner...sometimes, but not always, the artifi