Hi
I am trying to set up the failsafe in adrucopter .
I am using a APM2.5 running 3.1 software .
My radio is a 9XR with opentx software and an Open LRS module.
I have gone through the instructions and try as I might I cant get it to work .When I turn o
Read more…Hi everybody . hope someone can help
I am setting up my bixler with APM2.5 2.74 and Open LRS 1w .
I notice when looking at the HUD when I turn on TX the ground speed indicator went to
70 (this is when plane is sitting still on my living room table) whe
Read more…Hi everybody...
I have decided to switch 1 of my APM 2.5 from multicopter to plane.
I am using a bixler 1.1 stock setup .
But when in STABILIZE mode the plane turns to the right quite hard ..
I have the APM nice and level , any ideas please ....
Cheers
Read more…hi
my quad went out of control today and ended up in pieces .
it as been flying well in all modes for several weeks , only recent change is added minimosd .
here the log , hope someone can help me fi
Read more…hi everybody ..
I am switching from 3cell lipo to 4 cell lipo pack do i need to make MP changes ?
Its just when I plug the 4 cell in the quad wouldn't arm?
I don't have a current monitor .I power the APM from the ESC bec .
cheers
Read more…hi everybodyyy ..
just upgraded from 2.9.1b. to 3.1
I didn't upgrade the ppm , I tried but could not get it too .
the problem is the motors twitch when the apm2.5 is armed .
but it flys great .
Do I need to recalibrate the esc ?
I been flying the same se
Read more…Hi everybodyyy...
I had set a mission with around 20 way points.
My quad got to around halfway , way point 13 ,which was the furthest distance from the start
around 600meters . Then the quad made an auto landing with out finishing the mission .
I had t
Read more…I am looking for a bit of advise on how to smooth the flight out and slow take off speed down a little.
https://www.youtube.com/watch?v=pO17asbxAdI&feature=youtu.be
But I am very please with the test.
here my setup:
xaircraft 450
keda 1050kv
hobbywing skyw
Read more…Hi everybodyyyy…..
More alt/hold questions. I have quadcopter with APM2.5 running 2.91
Here 2 graphs 1 with moon gel 1 without .
This is with moon gel
This without
Does the graph with moon gel look OK ?
And if it does look ok can
Read more…Hi everybodyyyy...
I am running 2.91 on my apm 2.5 with a MediaTek gps (the small1 the one suppied with the 2.5 board when they first came out)in my quad .
in stabilize it works a treat . But today i tried the loiter which was very erratic .Then i trie
Read more…hi everybody....
problem is that my quad running an apm 2.5 with 2.9.1 software .
i am trying to setup the autotrim . I trim it so flying nicely ,land and switch
the channel 7 switch for 4-5 seconds on my DX8 then center the trims , then take off but
Read more…hi everybody ......
my problem is that minimosd works fine by itsself but when the 3dr radio fitted ,3dr radio works as it should and osd shows all characters. BUT the characters dont change all stay at zero as if the apm inform isnt going into the
Read more…