"Your suggestion then is to mimic the X4 plates in a thicker material? I was also looking at using these arm mounts. I would just remake the hole pattern to match. Auturgy said:
If you're milling yourself, you could use thicker plate (3 or 4mm)"
I'm looking for an open design that I can mill myself. I have a set of 8 U8 motors to be run with 26" props and I want to design a craft around that. I was thinking of taking a Tarot X4 and replace the stock arms with the arms from a Taror X8. The…
Can I monitor the voltage of a secondary LiPo and then trigger a PWM output if the battery reaches a predetermined voltage? I was planning on using this from Matek. It has a PWM on/off switch. I'm guessing I can watch the voltage with some sort of…
"How did you generate that graph? Thanks! Raph said:
Hi Scott,
Thank you for your input. Are you aware of a good way to check if the airspeed sensor is badly tuned? I ran through the calibration as directed; on the ground it shows a value of 3-4,…"