Gender
Male
About
Please tell us a bit about your UAV interest
Multicopter GPS controlled for photography
Hometown:
CA
Activity Feed
"If not maxmax who would you trust? Event38?"
I have used droid planner 1&2 and have been using the tower app since it came out. Now when I connect to my pixhawk, the Tower app says ""The Android Wear app and an Android Wear smartwatch is required". After saying that, the app will crash. Any…
"What did you use to seal the wires and the camera case? How is the GPS sealed? Same with the antennas and GPS?
I just got a WQ-550 frame from liftoffuav that is really similar."
I just got a WQ-550 frame from liftoffuav that is really similar."
"Thanks, I went with the HP2826 770kv. On 4s with 11x5.5 they get 1740g thrust with only 22.4A. With 11x4.7 the motors you linked get 1580g with 30.2A. I received my motors already, but am still waiting on other parts that should be here next…"
I am building a WQ550, it can fit up to 11" props and I have eight 4s 5000mah 30c batteries that I want to use. Eventually it will carry FPV and a gopro w/ gimbal and a landing gear, so I estimate its final weight around 2.4kg. I messed around…
"I see that there is follow me mode:
http://copter.ardupilot.com/wiki/ac2_followme/
but that simply just a fly to here command every 2 seconds. What I am looking for, is fly to here (follow me) combined with set ROI:…"
http://copter.ardupilot.com/wiki/ac2_followme/
but that simply just a fly to here command every 2 seconds. What I am looking for, is fly to here (follow me) combined with set ROI:…"
My end goal is to have my copter (pixhawk F550) follow a moving target (boat/car) while circling it with the camera always pointed at the target. I was wondering if there is anyway to do this currently.Could one use follow me mode on the pixhawk,…
"Thanks, I finally got a message back from 3DR, they said the only way to do it right now is with a PPM encoder"
"Have you found anyway to get the DX18 controller working?"
