"Hey, I tried to do the same basic thing and it seemed to take off and loiter for a second but then when it should have RTL and land it just seemed to go off into the field. I was wondering if you had figured out any thing yet?
"
Hey guys I had the apm acting as a stabalizer with out the magnetometer or gps connected and it flew wonderfully. I just received the magnetometer and gps in the mail and connected them as per the manual.. I then reset the apm using the apm setup.…
Hey guys I'm having issues with my yaw stick... I have no problems arming the motors however I can't disarm them? Also when I yaw right she will spin right but when i try to yaw left she spins to the right again?I'm using a futaba t7c tx and every…
"Thanks every one for helping me! finally ended up recharging both battery's (lipo and tx), and running though the initialization of every thing again... not sure what was different but i finally have it flying... for some odd reason I cant disarm…"
"hey guys so Ive gotten the radio calibrated and all of the esc's calibrated however once I connect the signal wires to the apm pins the motors just beep constantly. the battery is freshly charged and the switch is away from the pins. What should i…"
I'm building the adrucopter with a gaui 330x. I know the adrucopter's power distribution board the escs plug in and only the "+ -" gos into the location for motor one on the actual adrino board. Would it be ok if I plugged the "s + -" from each esc…
"Hey I have a 330x-s and am planing to convert it to run off the ardupilot instead of the gu344. I was wondeing if this is what you did and if you had any tips?"