Hi
I thought I would give -rc4 a go, but while testing, I noticed a 'problem' when switching into either Alt hold or loiter when the throttle is less than 50%.
If I spin the motors up in stabilize mode then switch to either Alt hold or loiter, all 4 mo
Read more…Hi all
Am I the only one or is the Mission Planner interface now running really slow.
It seems to be working but the updates seem to be a couple of seconds apart making it sluggish moving around menus and trying to setup things.
Any help would be greatl
Read more…My compass has East and West swapped which I suspect is because the AC2 code expects the compass to be component side down and soldered to the pins on the IMU
I have noticed the AC2 code and CLI doesn't seem to allow you to set the orientation of the
Read more…
I did a dumb thing (not the first time)
I hurriedly ordered some spare props and obviously didn't look at the size too well when ordering.
Instead of 10" I must have ordered 12" because I now have 2 sets of them.
What would be the down side of trying t
Read more…I have a standard setup ArduQuad which I have flown only a few times. I have had motor control problems on most flights where it has wandered off on it's own mission - no great damage. This is normally after minutes of quite stable flight (all solder
Read more…It seems that quite a few people are using the Turnigy 9x Tx/Rx with their ArduCopters.
I have bought one for future extra channels.
I have searched the various forum topics and can't find where anyone has documented setting up one of these.
Beside not
Read more…
What a great project this has turned out to be. It has been really satisfying just getting to this stage and I haven't even flown more than a couple of meters in testing.
I have completed most of the fine turning of the Quadcopter and have wired in a
Read more…Hi all enthusiasts
I must say that I am very happy and impressed with the supplied kit and am having fun assembling it.
Well done to the all the guys involved in the evolution of the hardware and software, I think in the months to come we will see a qu
Read more…Hi all
I have been trying to order an ArduCopter kit.
Does anyone know when the kits will be available again?
I have been advised to get on the email list to be notified, but never receive anything.
The production status wiki does not seem to be updated
Read more…