Gender
Male
About
Location
New City, NY
About Me:
I like build rc stuff specially rc helis. New building UAV.
Please tell us a bit about your UAV interest
I'm interested in build an arducopter.
Hometown:
New City
Activity Feed
I just ordered a new Magnometer because mine just got damaged that is what I think. I uploaded the ACM 2.024 thru anduino because I' m having problem connecting to the Planner. The issue is that when I use command compass in the setup I just get…
Since I installed APM 2.023 I' m not getting any value from the magnetometer. Before with APM 2.019 it was working. I erased the eeprom installed some other ardupirateNG code and still I'm not getting any value from it. Could be that mag got…
Has anyone here have any issues with the APM 2.023and the magnetometer?I installed the Version APM2.023and all I'm getting from the magnetometer is zeros. I'm not getting any data from it. In the setup I enabled it and it was working with version…
"I switched to CLI and GPS is connected too. In the black screen to erase the EEPROM I press "Y" key and nothing happen. I cannot type the letter Y or any other letter. I cannot pass beyond this point."
I have successfully uploaded the AC2 to my board. The issue is that when I get to the first set up in the mission planning screen and it asks to erase the EEPROM I cannot enter "Y" and the first set up stays hanging and shows Not responding. After…
I'm in the process of finishing my heavy lift quadcopter. I need some sugestions about the set-up. I need to know what size of props I should use with this motors too. I think that APC 13.6 props will be good but I'm not sure.The frame is made of…
Well, I'm finishing putting together my arducopter. I have followed everything as per wiki. connection and calibration thru CLI.Here is my calibration set-upFirmware 1.54Magnetom. offsets ((x,y,z): -108.50, -39.00, -17.00Accel offsets (x,y,z): 2058,…
"The only problem with it, is that how do I use the trasmitted adjustment and motor commads, just using the USB alone? I don't want to blow my out puts. I need to adjust all that. I'm going to try something else tonigh, to see if it works."
"Yes, it is a custom hardware set-up, I bouth the APM board and the oilpan boards from somebody else that decided to stopped his project and the GPS, magnetometer and other parts were ordered from DYI store. As per the power distribution board, it…"
I'm finishing up putting together my arducopter. Everything is connected and escs are calibrated. I uploaded the alpha code to the APM and the uploaded went well. I have a steady led green light. The problem is that when I connect the battery and…
Hello! I'm new to this forum so, please be patient with me. I need advice in an arducopter set-up that I'm building. This is what I have so far: Ardupilot Megaoilpan board APM4X AXI 2208/34 motors4x ACE 40A esc BIG-40 7-4V…
