Jose Jimenez's Discussions (8)

Sort by

I need help with my Magnetometer

   I just ordered a new Magnometer because mine just got damaged that is what I think. I uploaded the ACM 2.024 thru anduino because I' m having problem connecting to the Planner.  The issue is that when I use command compass in the setup I just get

Read more…

Magnetometer issue

Since I installed APM 2.023 I' m not getting any value from the magnetometer. Before with APM 2.019 it was working. I erased the eeprom installed some other ardupirateNG code and still I'm not getting any value from it. Could be that mag got damaged.

Read more…

Magnetometer problem

Has anyone here have any issues with the APM 2.023and the magnetometer?I installed the Version APM2.023and all I'm getting from the magnetometer is zeros. I'm not getting any data from it. In the setup I enabled it and it was working with version APM

Read more…

Help with APM mission planning.

I have successfully uploaded the AC2 to my board. The issue is that when I get to the first set up in the mission planning screen and it asks  to erase the EEPROM I cannot enter "Y" and the first set up stays hanging and shows Not responding. After t

Read more…

HEAVY LIFT QUADCOPTER

I'm in the process of finishing my heavy lift quadcopter. I need some sugestions about the set-up. I need to know what size of props I should use with this motors too. I think that APC 13.6 props will be good but I'm not sure.The frame is made of com

Read more…

Final touch set-up hepl!

Well, I'm finishing putting together my arducopter. I have followed everything as per wiki. connection and calibration thru CLI.Here is my calibration set-upFirmware 1.54Magnetom. offsets ((x,y,z): -108.50, -39.00, -17.00Accel offsets (x,y,z): 2058,

Read more…

I need help with 2 motors running!!!

I'm finishing up putting together my arducopter. Everything is connected and escs are calibrated. I uploaded the alpha code to the APM and the uploaded went well. I have a steady led green light. The problem is that when I connect the battery and plu

Read more…

Advice in an arducopter set-up

Hello! I'm new to this forum so, please be patient with me. I need advice in an arducopter set-up that I'm building.  This is what I have so far:

 

Ardupilot Mega

oilpan board APM

4X AXI 2208/34 motors

4x ACE 40A esc BIG-40 7-4V 18.8V

MAGNETOMETERS

GPS

spekt

Read more…