About

Gender

Male


Location

Kaohsiung


Please tell us a bit about your UAV interest

UAV & UAH are in my research team.


Hometown:

Tainan city


Activity Feed

Kenny Huang replied to Randy's discussion ArduCopter-3.2 beta testing
"Solved. Just push the update button in MP, then the PosHold just comes up."
Aug 31, 2014
Kenny Huang replied to Randy's discussion ArduCopter-3.2 beta testing
"Solved, just push the update button in Mission Planner, then the PosHold mode came up."
Aug 31, 2014
Kenny Huang replied to Randy's discussion ArduCopter-3.2 beta testing
"Just upload RC6 to Pixhawk, but Poshold mode is missing during mode setup  in Mission Planner 1.3.9."
Aug 31, 2014
Kenny Huang commented on Pekka Ahola's blog post Multiwii 2.2 stick configuration cheat sheet for Mode 1 transmitters
"Pekka:
In Mode1, the throttle and aileron are on the right stick. In Mode 3, the throttle and rudder are on the right stick.
These are described in the manual of Walkera DEVO 7E."
May 26, 2013
Kenny Huang posted a discussion
I play with Arducopter for over one year(from APM1.0 to 2.5). My quad(APM2.5) with V2.8.1 fly ok in auto, RTL, Alt_Hold, and Loiter modes. When I upgrade my quad to V2.9.1 , the RTL, Alt_Hold, and Loiter modes are also fine, but the strange things…
Mar 1, 2013
Kenny Huang replied to Gent Armedo's discussion APM 2.0 vs APM 1.4 on RTL mode
"During my flight test yesterday, the APM1.4 with code 2.27 will guide the airplane to fly lower and lower until it was switch to manual. Since the throttle channel setting is reverse in FUTABA 10C transmitter, do I also need to reverse the  throttle…"
Jan 10, 2012
Kenny Huang posted a discussion
Hi: One of my ArduPilotMega IMU can't work properly. The IMU was installed on the Ardupilotmega board as shown in wiki manual. It works fine in CLI mode, and all the LEDs show normally. When it was switched to Flight mode and reconnected the power,…
Mar 10, 2011
Kenny Huang commented on Paul Mather's blog post HK's GCS v1.1.1 is in need of translators
"Hi Happy:
I have translated it to Traditional Chinese (Taiwan), and it have been sent to your email.
 
Regards!"
Dec 16, 2010
Kenny Huang commented on Jordi Muñoz's blog post uBlox GS-407 Antenna Problems.. (Solution)
"I have ordered this Ublox GPS on March 26 from DIYDrones Store (the order number is 3234).
It never got any satellite. I even upgraded it to the newest firmware 6.02, and still got nothing in u-center and ublox tester. I think it's defective in the…"
May 7, 2010