Gender
Male
About
About Me:
Robotics Research Engineer
Please tell us a bit about your UAV interest
I want to build a cheap autonomous helicopter.
Hometown:
Seoul
Activity Feed
"Thanks for your comment.
Unfortunately, I don't have pixracer now but will look at it.
Johnatan said:
Nice build. Have you seen the Pixracer? It is much more smaller than the Pixhawk 1 and has better sensors."
Unfortunately, I don't have pixracer now but will look at it.
Johnatan said:
Nice build. Have you seen the Pixracer? It is much more smaller than the Pixhawk 1 and has better sensors."
Hi all,I newly developed a fixed wing drone with Bixler 1.1 from hk.Below picture is autopilot cockpit module I designed for pixhawk.I had to extend front section of the cockpit from its original length to fit longer pixhawk into the cockpit.Also…
"Very impressive system engineering and design. "
I flew quite a lot with pixhawk system with various setups and know about connecting devices like sonar, optical sensor or lidar.I felt confident configuring pixhawk system until recently I have an order to setup a pixhawk drone for autonomous…
"I think this is not a good solution. Since the video has no comment on what materials used for the ring and whether it is adjustable or not, how one can imagine the ring fits all? Kid's finger might be too small for the ring.
What if user loose the…"
What if user loose the…"
"Never mind. I managed to solve myself.
I finally can build the code and update the sound.
Thanks!
Kyuhyong You said:
It is very nice and useful tutorial. Thank you for sharing.
Could you explain how I can build the modules in /src directory?
I…"
I finally can build the code and update the sound.
Thanks!
Kyuhyong You said:
It is very nice and useful tutorial. Thank you for sharing.
Could you explain how I can build the modules in /src directory?
I…"
Hi all,I setup a pixhawk drone equipped with a servo controlled sprayer to automatically open nozzle during auto mission. For the survey mission, I included arbitrary waypoints before and after each survey line and set the output pwm for closing and…
"It is very nice and useful tutorial. Thank you for sharing.
Could you explain how I can build the modules in /src directory?
I tried make px4-v2-quad and upload but the tone does not change."
Could you explain how I can build the modules in /src directory?
I tried make px4-v2-quad and upload but the tone does not change."
"Never mind. I managed to handle this topic myself."
Hi All,I decided to build my own pixhawk version and just made compile environment on my mac mini with OS X Yosemite 10.10.5 and followed every instructions described in the ardupilot wiki page.Now I setup compile environment on Eclipse and…
Hi all,I am designing a drone for using pixhawk and need to retrofit the external USB and LED for my own design.So I draw schematics and circuit board for both USB and LEDs. USB works just fine however LED circuit does not work as expected. I tried…
"Thanks Andre for your reply. I should check the barometer as well. Its good to know atleast someone have discovered this issue.
Kyu"
Kyu"
Hello, I have been frequently flown with APM board 2.5.2 so far without major problems until recently updated to the latest firmware. After updating, I see "BAD GYRO" message appeared on the HUD and the attitude become upside down. I investigated…
Hello,I have been flying my quadcopter with mission planner in Korea and happy about its auto navigation flying. However, 1 out of 7 or 8 attempts the mission was failed due to lost gps signal in the middle of waypoints.As a robotics engineer…
