Hi need some help. I am currently configuring a quad with dshot150 on aux channels 1-4. Aux 1-3 are clearly outputting dshot150, I've confirmed this with my oscilloscope. The remaining 2 Aux channels will not output dshot or PWM so only 3 out of 4…
"Seem to be having the same issue occasionally with my DroPix Autopilot board, which is similar to the pixhawk. It tends to happen after a step temperature change. After calibrating accels in the warm workshop then going outside, it will sometimes…"
"Interesting. I would like to build a gas engined helicopter, but I'd be concered about the autopilots ability to cope with engine failure. Correct me if I'm wrong, but I think that the current software would stall the rotors and the heli would crash…"
"I can't remember excatly how it was drawn in solidworks. But Convert Entities can be used in sketch mode to copy profiles. The section is an old Clark-Y, the profile is constant along the wing, this made fabrication easier. I think you could still…"
I've also been following your work. For the wing boom mounts, I used part of the wing profile and did convert entity on the top side of the airfoil section, it can be helpful to save profiles as blocks in solidworks.
Constructing the boom…"
"The fuselage shell was vacuum bagged around a foam core. The foam was then dug out after the fuselage lid was cut off. The wind effect was similar to the X-frame. We were considering mounting the ESCs on the inside with heatsinks to keep it…"
"I had the same problem with my quad after installing a camera gimball. I think the servos drew to much current from the power module causing the autopilot to brownout and the quad to lose control. The Vcc log showed some transient under and over…"