"Success at last. after weeks of testing all the codes I flew sunday (I am in the UK) first flight with Beta code. flew all the waypoints, all working thanks Jordi. It ws a calm day no wind, on the second flight a did pretty good but could not find…"
"I have four complete set ups but one xyz sensor I been at it for over 5 weeks solid I cant get anything to work properly. This is not a complaint I understood what this site was about before I started the project. quite frankly a walk around test ok…"
"@ David.
I was a little fast answering you. when I read your post agin you said after calibration, I dont think I have done that will try it now. thanks.
Paul"
"@ David
I have always done that it, and it always looks perfect, as is the other WP. The way I understand the other guy who is printing this out from the program might! be the problem people are having with the model flying in one direction looking…"
"@ David Thanks for your startup procedure. I am going to try again today, I have worked on this al week 12 hours a day. What worries me now is the comment made earlier about the WP 0 0 ! If this is the case it wont work. but i did note that you have…"
"One quesyion for you. Doing a test on the ground it appears to work. when flying as soon as I switch to atuo it spirals down. Ok so I alterd the servo direction in the .H file which stops the spiral but it flys in the wrong direction. I am not sure…"
"Jordi. Are you saying we should not use the 233 demo2 code. I have just got back from flying, had 6 flights all failed by just flying away into the distance. It seemed that it was attempting to fly somewhere as it bank right then left to maintain…"
"I have four Ardupilots and have used all the 2. codes up to 2.3.3 Demo 2 .none of them have worked for me
However, I watched Jordi's video of the walkaround and something caught my attention.
The readout updates at about once per second mine update…"
"After loading 2.3.3 I did some ground testing but did not give any reliable results so I set the code for walk around mode, still can be sure its working. Now after setting the .h file back to normal mode the serial monitor prints out as it used to…"