Gender
Male
About
Location
Detroit Lakes, MN
About Me:
Heli guy getting into quad flight
Please tell us a bit about your UAV interest
Quad flight with possible FPV interests
Hometown:
Detroit Lakes
Activity Feed
"Something will likely burn up as it will not likely be a simple fix like shutting down the throttle. Still, better than having your fingers looking like the tomato in a ginsu knife ad.... "
"This is the one I have:
http://www.dpcav.com/xcart/1.2GHz-A-V-Transmitter-1000mW-Lawmate.html
The pigtail that it came with had a jst connector for the 3s Lipo and two outputs. One black/white/red that had 12V output and one brown/red/orange that…"
http://www.dpcav.com/xcart/1.2GHz-A-V-Transmitter-1000mW-Lawmate.html
The pigtail that it came with had a jst connector for the 3s Lipo and two outputs. One black/white/red that had 12V output and one brown/red/orange that…"
"I got it finally last night. I had a hell of a time getting one of the jumpers to bridge. I actually ended up using a small piece of wire to bridge it.
One thing I did was check the cabling coming out of the Lawmate Tx. There are two leads and…"
One thing I did was check the cabling coming out of the Lawmate Tx. There are two leads and…"
"I got it finally last night. I had a hell of a time getting one of the jumpers to bridge. I actually ended up using a small piece of wire to bridge it.
One thing I did was check the cabling coming out of the Lawmate Tx. There are two leads and…"
One thing I did was check the cabling coming out of the Lawmate Tx. There are two leads and…"
"OK, I will remember that . I have everything set up so I can just plug into my power distro board and go from there. I may send you some pics of my wiring if it doesn't work if you don't mind. I am extremely noob at this... :-)
Cheers,
Paul"
Cheers,
Paul"
"Thanks Mario. I did not solder the jumpers. I will give that a shot and if there are still issues I will get in contact with you and then try a Skype call
Thanks again,
Paul"
Thanks again,
Paul"
"Awesome!! :-)"
"I'm going to install my ardupilot 1 in a quadcopter, but was thinking of putting it (or another one) eventually into a plane. Been looking at the Bixler on the recommendations here but they seem to be out of stock in the US continually. I then saw…"
"I like it low cuz I'm checking it out while at work.... but yeah, it is a little too low... :-)"
