All my friends that flying NAZA asking me why i did not buy DJI NAZA as it work from the box.... I build my F450 based on APM 2.6 and still tuning it... Well it still fly like a boat on the sea.. Lots of oscillation etc. My friends have NAZA and
After all my quad start flying but i have very bad oscillations... I feel like i'm flying a boat on water... Every little stick move (roll/pitch) and quad bouncing. I know i need tune the PID but don't have any idea where to start ( i have a m
I'm finishing build of my first quad. Can someone take a minute to look what i did? Any advice will be greate about electronic placement etc. The ESC signal wires are temporary not in place just attached to spin up the motors. Reciver AR6210 w
I just fisnished the wizard conf. I connect the battery to the Quad and try the arm (without props), the RED led stop blinking but the motors don't spin slowly as is informed in AC3.1.2 info, when i push a little throttle and go down again motors
I'm finishing build of my first quad. Can someone take a minute to look what i did? Any advice will be greate about electronic placement etc. The ESC signal wires are temporary not in place just attached to spin up the motors. Reciver AR6210 w
I almost finished assembly my F450 with APM 2.6 and have 2 question before i go to the filed.
1. Should i made a first flight with GPS or without it? GPS have a compass onboard. It will be mounted on stand pole so if i crash/flip it will be destro
I'm ending my shoping (i have the F450 ARF and APM2.6 and GPS + comapss from 3DR) and wondering what mounting You use for the GPS? Is this will be good?
I read a lot now of how to build my multirotor and what is concern me is that every time when i connect the battery i will have to wait 5 min before flight to get well GPS lock. Is there any way that i can connect externall power source to Ublox