Location
Hong Kong
About
About Me:
:-)
Please tell us a bit about your UAV interest
Boats
Hometown:
Hong Kong
Activity Feed
"Thanks Ben, We would like to change "Battery Voltage" to "Fuel Level"."
Hello, I have a project which requires a gas tank sensor to talk to the APM 2.8 The gas tank sensor is the typical 0-190Ω variety like…
More and more government drone pilot and technician jobs are being advertised. If you are a school or training institution, you may wish to commission a build by people who are already supplying government drones. But what about the costs you say?…
"it is good as a back up radio. It can give you telemetry data and as mentioned you send send commands"
Was wondering if anyone has flown a biplane using Ardupilot or another system with any success. Should you have any experience in this, please let me know. Thank you !
Read an article by Jdrones a while back on how to contribute to the code source at DIY Drones. Found Pygame was rather essential for joy stick controls and mapping. Attached a small mapping program. It uses Open Street Maps. I wanted something…
Hi,Building a vehicle from scratch. It is a boat. Have it working as an FPV fairly well using a three year old Pi and PCA9685 servo controller and GStreamer for video.Would like to add a GPS function. Can write my own using C, but people have…
"Hi, sudo apt-get install python-opencv python-wxgtk python-pip python-dev Does not seem to work . Tried python-wxgtk2.6 and 2.8 too. Error message :
Package python-wxgtk is not available, but is referred to by another package.This may mean…"
Package python-wxgtk is not available, but is referred to by another package.This may mean…"
"Hi, About a year ago, I read a post about how to contribute . Not knowing where to start, I decided to write my one code. I am building a pooltest.png boat. It uses the Raspberry Pi, TDMA radio, Gstreamer. Designed my owned my own hardware…"
"Would like to post the optimal confitureat"
"Has anyone tried the Ubiquiti TDMA ? How does it compare to 5.8GHz WiFi ?"
Hello Prior, the code below would start the camera stream with no trouble. Now, it locks up the system. Anybody run into this before ? raspivid -t 0 -h 720 -w 1080 -fps 25 -hf -b 2000000 -o - | gst-launch-1.0 -v fdsrc ! h264parse ! rtph264pay…
"4631.jpg
I am looking at the bullet too for the attached boat. On the base station side, do you have any suggestions which radio to use ?
Thank you !
Harry"
I am looking at the bullet too for the attached boat. On the base station side, do you have any suggestions which radio to use ?
Thank you !
Harry"
"JDrones.com is in Bangkok. They are a DIY Drones reseller"
