Hi folks,
I'm trying to download the logs from the flash on the APM 2 (v2.73) using the CLI tool in Terminal...it doesn't seem to be possible.
I've tried the sequences below, but they all seem to be inhibited by the incredibly long connection process t
Read more…Hi folks, I had to buy a skywalker 1900 after I stuffed my original 1500 into some trees. Does anyone have a good, solid param file for their 1900 that wouldn't mind sharing? This would be tremendously helpful :)
spag
Read more…Hi everyone!
During Loiter, my throttle oscillates rather consistantly. The tuning graph suggests that APM is responding to airspeed (as opposed to altitude) because of the frequency of the oscillations and how it relates to my target alt.
If there we
Read more…Hi folks,
On the bench: When FBW_A is enabled, all control surfaces level off when I tip the plane 20 degrees up and roll it about 30 degrees right. When stabilize is enabled, all surfaces are level when the plane is level.
In the past, I've seen this
Read more…Hi Folks,
I've read lost about FBW on the wiki, notably this article (https://code.google.com/p/ardupilot-mega/wiki/FlightModesFlyByWire), which describes the mode as attitude control with manual throttle.
I'm using APM 2.4 and my FBW A runs my prop at
Read more…Hi folks,
I maidened my APM2 yesterday. It's running the latest code offered by the mission planner--2.34. I've got the skywalker parameters file from april 2012 set on it.
Just as the subject line says, when I switched to either fbw A or stabilize
Read more…Hi folks,
Has anyone had any trouble with APM2 taking 5+ minutes to get a GPS lock when used with a Frsky 2-way telemetry receiver?
spag
Hi folks!
I've just got my APM2 set up with X-plane 9 and before I've made any changes to pid settings, I find that every plane I've flown will not snap to level when stabilize is activated. In fact, all of them climb, some more aggressive than other
Read more…Hey folks,
I'm still reading and planning this winter's UAV, which will most certainly operate Arduplane.
I see that usually APM gets its power from the BEC off the ESC, via the throttle pins. The plan I have for my plane is to use a separate BEC to d
Read more…Hey folks,
It seems that an Xbee is the way to go! I'm going to use FrSky on my UAV & I've read that 900mhz video transmitters do not play well with Frsky receivers.
What about 900mhz xbees? Does anyone here use FrSky + Xbee 900mhz who can tell me
Hey folks,
I found this arduino wireless gizmo that appears to be a much cheaper alternative to the super expensive xbee.
Can anyone confirm that it works properly with Arduplane?
Hey folks,
I'm just about ready to get out the checkbook and buy an APM + IMU. Does anyone know of a pending revision/redesign/update I should wait for?
Thank you!
Chris
Read more…