Preamble
  • La Vergne, TN
  • United States
Share

Preamble's Friends

  • Christian

Preamble's Groups

 

Preamble's Page

Latest Activity

Preamble replied to Erik's discussion Feiyu-Tech Gimbal and pixhawk
"Which one, up or down? (PWM OR ANGLE LIMITS)"
Aug 9
Preamble replied to Erik's discussion Feiyu-Tech Gimbal and pixhawk
"Ok, I have finally made some progress in setting up my Feiutech gimbal where,  'Point camera here' and ROI seems to function as intended however,  it would be nice to have the subject (of the ROI) a bit lower in the…"
Aug 9
Preamble replied to massimiliano's discussion Unable to perform "ROI" or "Point camera here"
"Ok, I have finally made some progress in setting up my Feiyutech gimbal where,  'Point camera here' and ROI seems to function as intended however,  it would be nice to have the subject (of the ROI) a bit lower in the…"
Aug 9
Preamble replied to Mert's discussion Quadcopter nose dive on first flight in the group ArduCopter User Group
"Mert, replying to your last post.. Sounds like you loaded 3.5.1 APM which includes new features and New prearm safety check Before it will let you ARM the copter. There are two ways to resolve this, one more correct than the other however, if you…"
Aug 8
Preamble replied to Mert's discussion Quadcopter nose dive on first flight in the group ArduCopter User Group
"My vote is ESC calibration. ..."
Aug 1
Preamble replied to Christian's discussion Feiyu Tech mini3D gimbal pointing down on 3dr Iris+
"Having similar gimbal issue for a while..  Taranis output channel 6 maps to  RC9. For Tilt, I'm using the side nobs for this, winder in if that is an issue. Output channel 7 maps  to RC10 for Pan.. ( I did not configure Roll at…"
Jul 31
Preamble added a discussion to the group PIXHAWK
Thumbnail

Stop gimbal control

So, back before I installed a gimbal on my quad, I strapped a mobius camera to the front and all worked well with ROI missions using Mission planner. Setting ROI points caused the craft to yaw towards the ROI point as expected.Now, as I have a gimbal,  better camera,  rc control of gimbal pitch and pan... Missions using ROI point tries to point camera using gimbal controls, leaving original heading.  Problem is, my landing gear setup .. is in the way.. I'd like the original behavior. .Is there…See More
Mar 6
Preamble replied to Marco C's discussion back up power in the group PIXHAWK
"I haven't looked at the link referenced by Bill however, I will say that your approach to backup power is one of hardware not software configuration. You should be thinking "If my power module/port" fails then ______________ There…"
Feb 2
Preamble replied to DG's discussion DIY Y6 Pixhawk backup power question in the group Arducopter Y6 Owners
"I had trouble last year installing two strobes in parallel to my pixhawk. They worked fine (switch by rc channel 9) when the drowned was not armed and motors Not engaged however,  when they were the strobes were erratic with what looked like…"
Feb 2

Profile Information

Please tell us a bit about your UAV interest
Middleton
Hometown:
LA Vergne

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2017   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service