Hi.I'm re-assembling my hexa, from jDrones. I'm using the latest firmware [2.1] and mission planner 1.1.12. The problem is on the mission planner MAP....i can see my hexa, but it directs to another direction. I've setup magnetic declination for my city, "ribeirao preto" which is -20.21.....but but direction still wrong. My magnetometer is soldered on board, like Wiki recomends. Is this normal? This is the picture....the white arrow should be the right.…See More

Hi.This weekend i've changed my hexa from X to +....everything was fine, i was flying good with a lot of wind....but, on landing, my hexa fliped.Result: 2 motor-mount broken. I've made 6 new aluminium replacements and installed. After that, doing tests on my room, i got all motors running, but after about 2 or 3 seconds, 2 motors simple stop. After some tests, 3 motors got this same condicition: throtle-up->running, stop after 2~3 seconds. What could be? I never seen this before. Also, i've…See More

Hi.After some successful flights, last weekend i've started to test loiter and RTL. It's almost fine, but i need some tunnigng in loiter mode. Text from wiki:LOITER_PI and RATE PI's are used to control the copter.LOITER_P is used to push the copter to the desired location. This is overwritten by the copter on the fly and is not user editable.LOITER_I is used to overcome wind.Rate_P is used to tilt the copter. The higher the P the higher the motor response to achieve the desired turn…See More

Hi.I need to change my RATE_PIT_P and RATE_ROLL_P, but i can 't do it in mission planner anymore.I saw in another topic that i must change to CLI mode (swtich), but doing this i can't load params and change.....also, this error happen only with these two params.After trying to read in flight mode -> switch to CLI -> change params -> save, my RATE_PIT_P got 0,0! Now i reeally need to know how to change it in mission planner. Mission planner: 1.0.89FW: 2.0.49 TksSee More