"I am testing the program just to see if it can follow a route. The way I do it is not very advanced. I move APM2 where it will go. It goes to WP1, but will not continue to WP2.When I tested the V2.28 Arduplane went on to the next WP as soon as it…"
I used firmware Arducopter 2.4.1
It seems that it fails to find a way back (RTL mode). I am a bit unsure of this.I have not been in the air with APM2 yet. I run only the tests on the ground.
I did also tested the firmware…"
I also have problems with way point. It goes to WP1, but would not continue to WP2. I attach 2 photos.
Wp is also missing in the list of possible "Set WP". I have also written the WP and read them back to be sure they were…"