Hey guys. Im planning to transmit the audio using the Aomway 500 mw Video TX and a DJI Osmo Mic. How should i plug them so that i can do that ? Can i directly plug the Audio L and R of the mic anf Gnd to the Audio and Ground of Video tx ? Or i need s
Read more…I am going to build own user interface for my application which should :
show GPS raw data (coordinates, altitude)
show serial data from my sensor which is connected to drone via serial port (I have development PCB which provides TX and RX pins of Solo
Read more…Hey guys. Im planning to transmit the audio using the Aomway 500 mw Video TX and a DJI Osmo Mic. How should i plug them so that i can do that ? Can i directly plug the Audio L and R of the mic anf Gnd to the Audio and Ground of Video tx ? Or i need s
Read more…When thinking through the three different designs, I am pondering what would be the desirable traits of a Tri, Quad, or Hex, if the overall flight capability of each were the same in terms of the same lift, endurance, and speed.
Now I feel I should as
Read more…We manufacture custom battery packs for heavy UAVs using top quality cells made by Panasonic.
I have for sale a DJI Matrice 100 equipped with the DJI Guidance System, X3 4K camera/gimbal and Manifold Computer. This drone is in excellent condition and I'm selling it because I'm upgrading to to a larger drone with the newer Z3 zoom camera. This
Read more…hi friends i am using ardupilot 2.8 board.my board apm mission planner termilal tap not working. so i search solutoion. the diy solution gives arduino software eeprom clear.if i followed the solution my apm board not working. it says the planner show
Read more…
Date 1st May 2017
The quick tab showing most important selected parameters isn't updated through RF modems.
- Tested with 4 differents modems and 3 different computers.
- Going backward with version 1.3.46.3 build 1.1.6324.2857 and everything works agai
Read more…Where are the best resources for cameras with a FOV of around 40 degrees? This is equivalent to what we commonly call a "normal" focal length. And, once we find this lens, where would I find a 1" sensor at about 20 MP with a similar "Normal" lens tha
Read more…Is there a (standard) way that joysticks can be used in place of the more common controls that are included with all radio controllers?
Read more…Hi, if I may ask a basic question please.
If I am buying a specific zoom camera online that is said to fit the gimbal for the drone, then (taking into account that I am a total novice), then are the camera functions on the drone usually controlled v
Anyone have experience using a carbon tube inside another as a simple axial bearing ?
The application is a tricopter tail boom, its a 12mm tube & so must rotate freely with minimal play.
I guess a better solution would be a PTFE bush, but not so easy t
Read more…Hello fellow aviators,
I am part of an undergraduate team of Aerospace Engineers at Oklahoma State University. We have spent all semester doing research on and designing low RCS target drones to help train our Military. This weekend is our final capst
Read more…Hey guys, so after 9 months I finally got my large quad in the air. I changed ESC's from afro 30a to Hobbywing 40a. I went 40a just because. Anyway, I am running a pixhawk on a x650f frame that has been stretched. I am using 4114 330KV motors with 15
Read more…Hi, I have a good old apm 2.6 and I juste installed arduplane 2.4 (lastest firmware for my board).
The version of mission planner is 1.3.46
When I go to Configuring / flight modes, the choices I have is QStabilize, Qhover, QLoiter, etc... Its all quadp
Read more…Dear all,
My X8 fixed-wing (running under arduplane 3.7.1) stalled and crashed after entering a spiral of death caused by a too high bank angle. My X8 was successfully auto-tuned, it flew a few times before without any issues. After 30 minutes of squa
Read more…Hello guys,
I am doing a project with pixhawk and raspberry pi and I already have followed the steps of http://ardupilot.org/dev/docs/raspberry-pi-via-mavlink.html and got a communication link between the two devices.
I am using the support package of
1. Brushless Motor (4 pcs)
2. Electronic Speed Controller (Abbreviation: ESC, 4 pcs. Common brands have Hobbywing, Tatttu, Little Bee T-motor etc.)
3. Propeller (4 pcs)
4. Flight controller (The common brands have KK, FF,ADUINO Open pilot etc.)
5. Batter
Read more…Hello everyone,
We have released a megaphone for SAR drones:Sky Speaker-I,very good for missions like rescue,search,broadcasting over crowds,fire fighting,police negotiation etc.
Testing video
Features
1)Lightweight design,only 500grams for speaker
2)All-
Read more…