Gender
Male
About
About Me:
Just an engineer
Please tell us a bit about your UAV interest
Photogrammetry and remote sensing
Hometown:
Novosibirsk
Activity Feed
Hello friends.I'm trying to make my maja landing on parachute in a more perfect way (not like now). At the moment i use a mission like this:So, the land waypoint and the waypoint where the chute should be opened are located close to each other to…
"which radio modules do you use for telemetry? Haven't you tried to check them?
actually i'm flying on maja feeding ardu from the regulator's board bec and from the spare one bec."
actually i'm flying on maja feeding ardu from the regulator's board bec and from the spare one bec."
"ok, got the source from "svn checkout http://arducam-osd.googlecode.com/svn/trunk/ arducam-osd-read-only" repository.
In ArduCAM_OSD set:
"
#define TELEMETRY_SPEED 9600 // How fast our MAVLink telemetry is coming to Serial port#define BOOTTIME 2000…"
In ArduCAM_OSD set:
"
#define TELEMETRY_SPEED 9600 // How fast our MAVLink telemetry is coming to Serial port#define BOOTTIME 2000…"
Hello.I have MinimOSD v1.1 and it works fine when APM telemetry is configured for 57600. But my XBEEs work on 9600 only. So if there is a possibility to change OSD's serial baudrate to work on 9600 ?Where can i get the firmware source and which…
"to Ellison Chan, yes the board type is set to 1280"
"trying to compile ArduPlane V2.34 for APM1 (ATmega1280) with any version of arduino but getting:
c:/arduino-1.0/hardware/tools/avr/bin/../lib/gcc/avr/4.3.2/../../../../avr/bin/ld.exe: ArduPlane.cpp.elf section .text will not fit in region…"
c:/arduino-1.0/hardware/tools/avr/bin/../lib/gcc/avr/4.3.2/../../../../avr/bin/ld.exe: ArduPlane.cpp.elf section .text will not fit in region…"
Hello everyone !I have an APM 1 with ArduPlane V2.28 firmware.I'm trying to use "DO_SET_SERVO" command to open the chute.To test its action at the table before using it in flight i connect a servo to the 5th channel and make 4 commands in APM…
Hello, friends!I have a question about the ability to use APM Planner coupled with ArduStation for antenna tracking. Actually i want to try the new 3DR radios instead of XBEEs.I tried different settings in "Antenna Tracker" options section in the…
"the ability to change the baudrate without reflashing is cool
very nice design, Colin, thank you!"
very nice design, Colin, thank you!"
"I have nearly the same problem [ http://diydrones.com/forum/topics/apm1-xbeepro900-xsc-9-6kbps-issues ]
Take into consideration this thread [http://diydrones.com/forum/topics/xbee-signal-interference-or-1 ]"
Take into consideration this thread [http://diydrones.com/forum/topics/xbee-signal-interference-or-1 ]"
Hello friends! I'm a very new to the diydrones community so please don't beat hard )I've got:1) ArduPilotMega12) 2 x XBee Pro 900 XSC modules: - http://www.sparkfun.com/products/9085 - http://www.sparkfun.com/products/90873) XBee Explorer…
