Gender
Male
About
Location
London
Please tell us a bit about your UAV interest
work
Hometown:
London
Activity Feed
Hello,i have attached a servo to the channel 5 that it was free. On Mission Planner, i have configurated in Camera Gimbal the Tilt in RC5 and input Channel RC5. In my RC, i enable the channel5 but it doesn't work. By the way, when i disconnect and…
Hello,i am using mavproxy to communicate the drone with my laptop. I am trying to control it from the laptop and works well but it is a experimental stage, so, when i send a message using mavproxy to the drone i lose the control from the radio…
Hello everyone,i want to change from Stabilize disarmed to Stabilize armed using MAVLINK. I have to send a MAV_MODE message:Set the system mode, as defined by enum MAV_MODE. There is no target component id as the mode is by definition for the…
"Hello,
with this module i can control the Arducopter using a Joystick? I ask this because i don´t have joystick to try it and i have to buy one.
Thanks!"
with this module i can control the Arducopter using a Joystick? I ask this because i don´t have joystick to try it and i have to buy one.
Thanks!"
Hello guys,i am trying to understand how the joystick work in the Mission Planner. I guess if i can use the joystick to control the Arducopter, Mission Planner has to send commands using MAVLink to the Arducopter. I have read the joystick.cs file in…
Hello,I have attached to the Channel 5 a Servo. So, when i turn on or turn off this channel the servo moves well. My problem is the next, i need to have the channel 5 turn on always and trying to move it modifying the Arducopter Software or maybe…
Hello everyone,i want to use a pin of the APM board to attach my Servo because i want to do something when the drone is flying, I wonder if it is possible this. In that case, where should i attach it? In the channel's panel?Thanks!
Hello,i am trying to fly my Arducopter. I have followed the instructions for the configuration. When it is taking off around 20 cm on the ground it fall down. Why could it be? Thanks.
"Hello, i am trying your package but it is necessary turn on the Arducopter with the battery? Can't i use just the USB cable? Because it is waiting the heartbeat always.
Thanks"
Thanks"
Hello,i am trying to understand how does it work mavlink_ros . There are two topic, /fromMAVLINK and /toMAVLINK. From the /fromMAVLINK topic i received information about: seq, stamp, secs, nsecs, frame_id, len, seq, sysid, compid, msgid, fromlcm,…
"I have recorded a video with the beeps.
https://www.youtube.com/watch?v=l0kAO0jJgbs&feature=player_embedded"
https://www.youtube.com/watch?v=l0kAO0jJgbs&feature=player_embedded"
Hello guys,when i turn on my Arducopter doesn't stop to make constant sounds. Why can it be? Maybe a bad connection?Thanks!
Hello everyone,someone have an idea about how can i send a command using XBee? For example, set a waypoint. I have read about Mavlink protocol.Thanks!
"Thanks for the answers. I can use a checksum verification to solve a bad control link, right?"
Hi everyone!Anyone has an idea about how can i control the Arducopter from a tablet? Do you have some document about this?Thank very much!
