Gender
Male
About
About Me:
Electronics Engineer
Please tell us a bit about your UAV interest
Robots and Rovers
Hometown:
BB
Activity Feed
"Thank you for you reply. I just tried it and it work great."
"I really do not want to power the receiver through the APM since I will have 2 servos on it used for pan/tilt.
Can I simply connect the + and - of my 5V power source one of the servo channel + & - on the receiver thus powering it ?
of course the…"
Can I simply connect the + and - of my 5V power source one of the servo channel + & - on the receiver thus powering it ?
of course the…"
Hi GuysSorry for the dumb R/C question but I'm a newcomer when it comes to this R/C stuff.I'm trying to make a 4WD rover using APM2.6.I have an eight channel receiver but I can figure out how to give power to the receiver.The receiver can accept…
"let me ask one more question, is the right stick self centering ?"
"So only the right stick is used (2 channels correct) ?
Does the left stick do anything ? Can I use it to control a pan/tilt mechanism ?"
Does the left stick do anything ? Can I use it to control a pan/tilt mechanism ?"
Let me ask a silly question.I'm trying to build a custom R/C controller to control my rover.What sticks are used to control a 4wd rover with skid steering ?can someone explain what the left stick does and what the right ?
"My hardware has 4 pwm outputs (like an R/C receiver). Output "A" will be used for mode selection and it will provide 3 signal values. Depending on the signal value, the corresponding mode will be selected. According to your previous post, these…"
"Thanks for the reply.
So if I send a signal of 1200 it will go to Auto, 1500 it will go to LEARNING and 2000 it will go to Manual ?
What about the signals required for waypoint add and waypoint delete and throttle/ direction control ?
I do not have…"
So if I send a signal of 1200 it will go to Auto, 1500 it will go to LEARNING and 2000 it will go to Manual ?
What about the signals required for waypoint add and waypoint delete and throttle/ direction control ?
I do not have…"
HiI'm in a process of building a 4WD rover using skid steering and will be using the APM2.6 as my autopilot.I do not plan to use an R/C remote control transmitter/receiver for control but I would like to know what type of PWM signals ( there values…
"I have an OTG cable for my Nexus 7 tablet. 1. Do you think that I can use the telemetry set with the table ? 2. What information is relayed when using the telemetry set ?"
"Thanks for your replies, No to finish my chassis and start adding the brains to it."
"Hi and thanks for your quick reply.
Is DroidPlanner suitable for ground rovers ?"
Is DroidPlanner suitable for ground rovers ?"
HiAre there any thoughts to port mission planer to the android platform ?
