About Me:
Two quads and one fixed wing.
About
Please tell us a bit about your UAV interest
Just beginning.
Hometown:
Baton Rouge, LA
Activity Feed
"Using Arduino IDE 1.0.1 I am still getting compile errors. Says conflicting return type associated with uint8_t. Any ideas?
There are 2 source codes in your zip file. Is the OSD the original and the beta your changes?"
There are 2 source codes in your zip file. Is the OSD the original and the beta your changes?"
"When you set up the flight modes in the mission planner just check the 'simple mode' box next to it. That makes simple mode permanent for that selection. On my quad I have all flight modes checked to 'simple'. No need for an external switch.
In you…"
In you…"
Using the Wiki instructions for flashing the APM2 I am unable to connect to USB with the FLIP software.After connecting to USB port and installing the jumper on JP2 port I use a wire to reset the Atmega. At that point I hear the USB…
"Is there anyone using the auto take off feature out there????
How is it working for you?"
How is it working for you?"
"Can any of the guys that wrote the software chime in here and tell me how auto takeoff is supposed to work?
Throttle position?
Resetting the mission and starting over?"
Throttle position?
Resetting the mission and starting over?"
"Is there anyone who knows how auto takeoff supposed to work?
Is anyone else using this feature. Sure makes launching easy when it works!"
Is anyone else using this feature. Sure makes launching easy when it works!"
Where is the documentation that explains Auto Takeoff?The little I found says the throttle is manual. I have it programmed as the fist step in a mission. As soon as I select auto mode the throttle goes to max. If I land, reset the mission and select…
"I think FBW-B uses throttle for altitude control where FBW-A uses elevator. You do have to have the air speed sensor though."
"I had to reset the mission. It was trying to go to a waypoint other that the first one even though I downloaded a new mission."
I have takeoff as the first command in my mission. Up till today as soon as I would enter the 'auto' mode the throttle would go to 100% and I would hand launch the plane. After downloading a mission today with takeoff as the first command, when I…
"Curious as to why you want one that large? Seems like the RiteWing Zepher II is plenty big w/ a 56" wing span. http://www.ritewingrc.com/buy-cores/wing-cores/
He has already done all the R & D. Very stable platform."
He has already done all the R & D. Very stable platform."
"Is there anyone that can tell me how voltage and current is handled in the mission planner? Is mAHr available anywhere? Any future plans?"
I have searched and can't find much information on how voltage and current is handled in the mission planner. I have a APM2 and 90A AttoPilot that brings in voltage and current. I have set the size of the battery in mAHrs in the setup. I have also…
"I would be interested in this capability too. I have a couple of applications where this would be helpful."
A couple of versions back there was a tab to level the plane in setup. The only thing I can find now is a tab to level a quadcopter. Is this what is used to level the plane?
