"I'm sure you need set up your radio to fly the wing too, if u havn't. If your aileron, elevator, throttle and rudder aren't in channels labled 1-8 they are not being seen as so."

"One 5V power for Aux 9-14 channels but numbered 1-6 on my pixhawk and then 5V power for the 1-8 channel. The 1-8 are your (in this order) aileron, elevator, throttle, rudder, and 5 I think is flight mode the other 3 not sure. I have tied up with…"

"For aileron, elevator control, obviously..... Right?"

"Hi Chris,
I've installed new vibration dampers and this is the new auto read out.It would appear all looks good and ready for an autonomous mission> Would you say so? I did test rtl with the flight mode initiated. Thank you for your help.
 
Log File…"

"Hi Chris,
Yes, I fly with the 915mhz connected to tower to monitor the mission. When the drone entered rtl and I had no controls I checked the tower app and it showed the drone was in rtl. I do not fly with wifi and I have flown in this spot several…"

"Hello,
Yes, you are correct it climbs to an altitude then rtl. That is exactly what it did, scared me. I was in stabilize mode and fail safe is set up with the radio. Bench tested but never had the guts to live fly test.
Unfortunately I am not to…"

"I did not turn off the tx and was about 10' maybe away when it entered rtl. I have a dsmx sat remote rx plugged into pixhawk. Do you think the vibrations would cause the altitude to drop? I was thinking it was a weight issue however I have plenty of…"

"Log File C:/Program Files (x86)/Mission Planner/logs/HEXAROTOR/1/2016-03-21 17-49-34.logSize (kb) 8853.876953125No of lines 106452Duration 0:06:06Vehicletype ArduCopterFirmware Version V3.3.3Firmware Hash acf2e10cHardware Type Free Mem 0Skipped…"

"i might add that im using duel gps"

"Thank you for the response. The log would be in tower correct? I erase logs in tower so its easier to find them when geo tagging with solo. I was wondering if I needed to do something in the params."

"You'll need to relocate them on the flight controller. As the motor positions have changed."

"When I installed firmware onto my apm 2.6 it would install the A version only. What your asking about flipping the tail boom seems it would put the motors spinning in the right direction. Just relocate the numberING on the fc."

"have u spolved the sattilite display issue?"