Location
Oppegård
About
About Me:
I am a 3D software developer with a strong interest in radio-controlled stuff
Please tell us a bit about your UAV interest
I have been flying rc helicopters for a few years. Now I want to explore the world of UAVs!
Hometown:
Vadsø, Norway
Activity Feed
"Well, it failed again today... but in a slightly different way :( It started spinning around the yaw axis uncontrollably, and then crashed. I had no control on throttle. Two of the motors (1 and 3) continued spinning after it crashed. I was unable…"
"Can a BEC brownout cause problems like this? I'm using the BEC in esc #1. I have a stock ArduCopter with telemetry, but no other electronics at the moment."
"Now I've tried replacing the ESC and motor that was just screeching. Same sad story."
"Ok, I have reflowed the solder joints on the compass. The problem still persists.
Is there anything else I can try?"
Is there anything else I can try?"
"After a few flights, it got much better. Compass offsets, perhaps?"
"Now the "logs" command in CLI just hangs. "
"Ok, I tried again now. What happens is:
1. I take off and hover. It hovers nicely without any drift
2. I apply some slight left rudder. Now the copter starts rotating to the right.
3. I apply even more left rudder. Now the copter rotates the…"
1. I take off and hover. It hovers nicely without any drift
2. I apply some slight left rudder. Now the copter starts rotating to the right.
3. I apply even more left rudder. Now the copter rotates the…"
"Is 2.1 the recommended version to use if we want the most stable and reliable code? I have APM1."
"Will those patches find its way to an official release for the APM1280? Or is 2.0.55 the last official release for this APM?"
I have a stock ArduCopter frame with ArduCopter 2.0.55. I have enabled the mag, and it's soldered as described in the wiki.It hovers very stable, and yaw is not drifting. However, when I apply yaw input with the rudder stick, the quad yaws in the…
Thanks for all the hard work, guys! Is this a stable release, or is it still considered beta?
"And a followup question: do I need to connect the ground from the PDB to the BEC's output ground?"
I'm having problems with my ArduCopter suddenly flipping over and crashing. I'm wondering if this is cauased by a brownout. I have connected a micro servo for camera control, so it's drawing a little more current than a standard ArduCopter. I have a…
"Cool. Keep up the good work!
"
"
According to the news page, 2.40 was a release candidate for the first non-beta code. One would expect that this meant that only bug fixes should make it into the codebase. However, it seems like the code is still being actively developed with new…
