"Maybe that's why im having to land at 2500mah. I assumed the current sensor was wrong because i had to go in and mess with the voltage to make it accurate.

You had a similar experience?"

"After the first cycle. Took it to 50%. Charging at 1amp my charger started beeping telling me im fvcked and i grabbed the bag and it was toasty. Tossed it in the swimming pool.

I ordered the multistars when i bought the iris. Dont get me wrong, it…"

"Yeah its not that im afraid.  It shows this same reading on my minimosd which is what bothers me.  This is my cheapo fpv rig.  I just wired it up with bluetooth so i could connect my phone whenever and change parameters easily."

"Yeah that parameter is at 12.02. Ill fiddle with it to get it right. Its kind of silly when i first arm it and take off seeing my voltage go to 11.4 volts.

Thanks!"

"Yeah ive done this to about 4 fixed wing and 3 multis. When i select the 3dr 4 in one esc. Everything is greyed out and i cant change any values.

Im running 3.21 if that makes a difference"

"these are the 4 in one esc's that cost 130 each. If this blows again im just going to grab 4 simonk escs and a power module and save 50 bucks"

"probably flying a phantom.  I had to call them and two different sales reps told me to order it on the web site.  Finally number 3 knew it was not and i got it overnighted.  Just finished the install and test flight."

"oh wow.  Yeah im at 1995 and 1011 now.  

Thanks!
Jeff"

"Thanks for the response steve.  Another question.  whats the problem with exceeding 2000?  My taranis hits 2006.  

Thanks
Jeff"

"I pushed my trim to max and redid the radio calibration and im good.  Thanks!  Maybe this is something that could be addressed?"

"Just put RC14 on my tricopter.  Redid all my calibration and im getting "prearm check fs_thr_value" warning for my prearm check.  my throttle off pwm is 982 and on is 993.  Failsafe is set to 984.  Any ideas?
I would use my frsky x8r with sbus for…"