Gender
Male
About
Location
Kuj-Pom
Please tell us a bit about your UAV interest
Drones..
Hometown:
Chełmno
Activity Feed
"Hi today I let the autorun again, I updated to AC3.3 rc 10. In the platform, added gimbal with GoPro, I lifted the weight change a parameter, THR_MID to 32%, and MOT_THST_EXPO changed from 0.75 to 0.65. After these changes finally my kopter is…"
"Hi, thank you very much for checking the Log and for advice. I will try to play with the parameters Throttle Rate, or Throttle Accel P and I, and carried out again autotiun. Not only gives me peace parameter MOT_THST_EXPO I do not know how well that…"
"Hi, this is not the new quad, I changed engines and propellers, FC Pixhack flew from AC 3.1.5 successfully on old engines and propellers 12 " on 3.3 rc5 had the best flying quad so far. The propellers 15" also flew but earlier on AC 3.2 autotiun…"
"Hellohas just I made a new quad, gave new engines TM 4006 380kv and propeller TM 15/5, all on Pixhawk and Ublox M8N, total weight, with battery, 6s10000 mAh came 2600gr, I hover at 30%. Ive loaded the latest soft 3.3 RC9 and ran autotiun, the effect…"
"Try this. Connect the USB cable to the PC and to pixhawk, at the same time connect to the port telemetry, programmer ftdi. In this way saved their fc, despite the lack of detection by USB, fc was detected by FTDI and fw be received any fc came to…"
"Exactly, it looks to me very strange and suspicious cyclically, as if something had ended and began, a filter, a loop program ?. Once again, I checked the drive, and it can not be a better balance, carbon frame, rigid, propeller only 12 inches,…"
"Hi, thanks for the information. So, is it acceptable vibration standards will change? from + 3-3 and -5-15? Do I have to worry vibration level? Besides great work"
"HiTests Quadrocopter all the time and I have a problem that previously did not exist. Increased vibration levels appeared cyclical peaks, perfectly balanced drive, hovering vibrations contain from +1 to -1, and never had these peaks are now shown on…"
"HI!! AC test 3.3 rc1 continued. I changed the parameters of the ATC and Autotiun the followingATC_ACCEL_P_MAX, 110000ATC_ACCEL_R_MAX, 110000ATC_ACCEL_Y_MAX, 36000ATC_RATE_FF_ENAB 1AUTOTUNE_AGGR 0.1I waited for nicer weather and turned autotiuna.…"
"HI!. Thanks for the information always so I do from AC 3.1.5 and it works quite well. But now, Pitch and Roll has a very low P rate and very high I, while Yaw too high P and I corrected what I can in this way"
"Ok thanks for the information. Log rar packed because he had more than 17 mega and joined to the previous post ..."
"HiYesterday I installed AC 3.3 rc1 and today I ran Autotune. The result is not good, there is some overshoot, the yaw jumps.. Adds a log of my flightbest regards2015-04-15 08-18-41.rar"
