Setting time on Pixhawk

Hello everyone,

Is there a way to set the time on Pixhawk when using telemetry? I know that once Pixhawk acquires a solid GPS lock the time is set based on the given location. But if I want to see the actual time of Pixhawk for me to either change it

Extracting telemetry log

Hello everyone,I am trying to extract the Telemetry log from pixhawk. But when I go to the HUD of mission planner and clicked on telemetry log, I am not able to see any telemetry log to open.Any help is appreciated.

Using an app to record complete flight mission

Hey everyone,

I would like to extract in GPS coordinates (Latitude, longitude, and height) the complete trajectory of a fly, but I do not want to set any waypoints. If I use telemetry, I know it is possible to get the different logs to find the comple

Pixhawk and bad health compass

Hello everyone,

I am using ArduCopter v3.2.1. As I looked at the Flight Plan HUD screen on MP, I see the picture of the quad not in the location it should be. It might be a few feet away from where it should be, and the orientation of the quad, that i

Pixhawk and RTL

Hello everyone,

I am using Pixhawk on a quadcopter. I had gone over all the wiki's about how to set up RTL. Flying in stabilize mode the other day to test RTL, I toggled the switch to RTL, and the quad just started to descend as if all motors had sto

Traxxas Slash Manual Mode is not moving forward at all

Traxxas Slash won't move forward in either mode

Hello everyone,

I am using a Traxxas Slash vehicle-- as the one I am showing in the link:

https://drive.google.com/open?id=0B4rmg ... GpYWC02Nlk

I followed the setup from the wiki. However, the car does not move forward just the steering on Manual mode

FrSky Radio and D8R-II plus receiver

Hello everyone,

I have a Frsky Radio and a D8R-II plus receiver installed on my APM 2.6. From what I have been reading, the D-series receivers, in this case the model I am using,  don't support the D16 mode, which has the failsafe feature. The D8 mode

Pixhawk and DJI Spreading Wings S900 Frame Kit

Hello everyone,

I am planning to build a hexacopter using the DJI Spreading Wings S900 Frame Kit, Pixhawk, and  T-motors. I will definitely appreciate any suggestions about any other frame or motors to use or if someone has already done what I am plan

What motor brand to use

Hello everyone,

I am looking for a high performance frame that is able to lift around 4-5 lbs. I have looked at the Tarot 650 and Tarot 680. But other than these two carbon fiber frames are there another type of frame someone may be able to recommend

What frame and motor (ESC) brand to use

Hello everyone,

I am looking for a high performance frame that is able to lift around 4-5 lbs. I have looked at the Tarot 650 and Tarot 680. But other than these two carbon fiber frames are there another type of frame someone may be able to recommend

PIWHAWK and AERO SKY QUADCOPTER

Hello everyone,

I am trying to fly an  AeroSky C6 RC 6 Channel Carbon Quadcopter Almost Ready to Fly that I modified by installing a PIxhawk flight controller, switch, buzzer, and compass. As the Radio, I am using an FR Sky Taranis. I did the whole se

FLYSKY FS-I6 radio and APM 2.6

Hello everyone,

I got the FLYSKY FS-I6 radio and using an APM 2.6. I have tried to do the configuration between the radio and the receiver. Any help as far how to do it is appreciated. Also, I tried to set up the different flight modes, but I have com

Obtaining GPS coordinates and time

Hello everyone,

I want to get get the GPS coordinates and time travel of set waypoints. I was reading about accessing the data log to view this info, but I don't get to see any time.

What I am trying to do is to set waypoints and at each waypoint to ge

PIXHAWK and Telemetry

Hello everyone,

Using telemetry (3dr radios), is it possible to change to a new mission (different waypoints) in the air once a set of waypoints had been issued on the ground?

I asked because I have been reading the forums, but I have not found much in

Communicating MP through MAvlink using SSH

Hello everyone,

I am using a wifi pineapple to capture wifi signal strengths on a quadcopter using Pixhawk. I have no way to connect Wifi Pineapple to Pixhawk for Pixhawk to be able to receive data from Wifi Pineapple and the quad to navigate to the l

Qgroundcontrol-Mavlink-Pixhawk

Hello everyone,

I am working on a project about an autonomous quadcopter that is able to track the strongest wifi signals and find location. I am using an arduino to get the wifi signals(or maybe a wifi pineapple), but I don't know if there is a way f

XBEE and PIXHAWK

Hello everyone,

I am working on a project to capture wifi signals flying a quadcopter using Pixhawk. I was reading the pixhawk tutorials, and I came across one that shows Xbee configuration - http://pixhawk.org/peripherals/radio-modems/xbee.

Following

quadcopter using Piwhawk to catch wifi signals from the ground

Hello everyone,

I am working on a project using a quadcopter having a pixhawk as my flight controller. Is there a way for me to connect to wifi signal strengths using pixhawk, but I don't know what other piece of antenna. I thought about using wifi pi

Pixhawk and wifi pineapple

Hello everyone,

Has anyone done any work on connecting wifi pineapple to Pixhawk flight controller? I have been doing a search, and I have not found out any info so far.

Thanks for any info provided.