Gender
Male
About
Location
Olival
Please tell us a bit about your UAV interest
Ardurover Aducopter
Hometown:
Olival
Activity Feed
"Hi,
I have the same problem. And the same results. However i have a fraid of flying with the one gps connected on serial4/5.
Do you have tested? "
I have the same problem. And the same results. However i have a fraid of flying with the one gps connected on serial4/5.
Do you have tested? "
"much work we must work. First legalize security system of drones to protect the citizen (parachute etc). We need to think many drones on the air. Second attribute a identifier for each drone. Thrid create a virtual road with the air with controlled…"
"Good challenge... Thanks a lot... "
"Hi,
You have tried ARM using the groundstation? Is the same problem?"
You have tried ARM using the groundstation? Is the same problem?"
"thanks a lot for your response.
I have tested everthing, i believe the motor configuration are correct. However when i take off i adjust the trims. But the radio are very sensitive.i cant control the hexa"
I have tested everthing, i believe the motor configuration are correct. However when i take off i adjust the trims. But the radio are very sensitive.i cant control the hexa"
"i have this problem
https://www.youtube.com/watch?v=hMQvY_BeJ2Y
is the same.
The solution is Inflight-Calibration?"
https://www.youtube.com/watch?v=hMQvY_BeJ2Y
is the same.
The solution is Inflight-Calibration?"
"Umer,
Do you have solution for this problem? I hexa have the some problem. The hexa tens to move"
Do you have solution for this problem? I hexa have the some problem. The hexa tens to move"
"Hi there,
Do you have resolve this problem? I have the same problem. I cant stabilize my hexa. My controller is pixhawk and my firmware is 3.2 rc 3. I cant flight"
Do you have resolve this problem? I have the same problem. I cant stabilize my hexa. My controller is pixhawk and my firmware is 3.2 rc 3. I cant flight"
"ok. I tested the motor everything is ok. However when i change the PID the values is more stable. I believe is necessary new values for PID.
However i tested the direction of the motor again.
.
Thanks a lot"
However i tested the direction of the motor again.
.
Thanks a lot"
"yes. The are corrected calibrated. The values generated by the controller are wrong. For example i test the hexcopter without props. I have armed the system and analyse the values in the main out. When i try to take off (only throttle) the rotation…"
Hi there,I have bought a tarot 680 pro (hexacopter), pixhawk and r70008 futaba receiver.So the firmware compatible to my hardware is hexacopter X Arducopter 3.2.After connecting all device, i calibrate the radio, compass, mag, esc, etc. Everything…
"Hey,
Thanks Philippe. However this solution is to analogread. If i want to write in the analog? What is the solution?"
Thanks Philippe. However this solution is to analogread. If i want to write in the analog? What is the solution?"
Hi,I am new in this arduino and ardurover world. I'm starting to analyses its full functionality etc..My question is if we want to insert several proximity sensors (Sonar) to detect obstacles.For this functionality specific library the Wire.h…
